HP HP NC150T - Manual

HP NC150T PCI 4-port Gigabit Combo Switch Adapter User Guide 1-1 1 Introduction Adapter Overview The HP NC150T PCI 4-port Gigabit Combo Switch Adapter is a 32-bit/66MHz, PCI, Ethernet adapter and a 4-port Gigabit Layer 2 Unmanaged Ethernet Switch. This device provides an on-board connection between ...

Introduction 1-2 HP NC150T PCI 4-port Gigabit Combo Switch Adapter User Guide Figure 1-1: RJ-45 port and LED locations Table 1-1: 10/100/1000 LED Operations for the NC150T PCI 4-port Gigabit Combo Switch Adapter LED Display Description On 10/100 Mb link to the network is established. Off No 10/100 M...

2 Installing the Adapter Overview This chapter describes installation precautions and explains how to install the adapter. It also describes how to connect the network cable. WARNING: To avoid the risk of personal injury or damage to the equipment, consult the safety information and user documentati...

Installing the Adapter Installing the Adapter in a Server Refer to the HP ProLiant server documentation for additional information on how to safely install a PCI card in the server. Figure 2-1: Installing the adapter in a server CAUTION: If the server is not PCI Hot Plug compliant, power it down and...

Installing the Adapter HP NC150T PCI 4-port Gigabit Combo Switch Adapter User Guide 2-3 Connecting the Network Cable IMPORTANT: Do not connect more than one NC150T PCI 4-port Gigabit Combo Switch Adapter port to any single other switch model. IMPORTANT: Do not use the NC150T PCI 4-port Gigabit Combo...

A Regulatory Compliance Notices Federal Communications Commissions Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in ...

Regulatory Compliance Notices For questions regarding your product, contact: Hewlett-Packard Company P. O. Box 692000, Mail Stop 530113 Houston, Texas 77269-2000 Or, call 1-800- 652-6672 For continuous quality improvement, calls may be recorded or monitored. For questions regarding this FCC declarat...

Regulatory Compliance Notices HP NC150T PCI 4-port Gigabit Combo Switch Adapter User Guide A-3 European Union Notice Products bearing the CE marking comply with the EMC Directive (89/336/EEC) and the Low Voltage Directive (73/23/EEC) issued by the Commission of the European Community. Compliance wit...

B Electrostatic Discharge Overview To prevent damage to the system, be aware of the precautions you need to follow when setting up the system or handling parts. A discharge of static electricity from a finger or other conductor may damage system boards or other static-sensitive devices. This type of...

C Specifications NC150T PCI 4-port Gigabit Combo Switch Adapter Specifications Table C-1: NC150T PCI 4-port Gigabit Combo Switch Adapter Specifications Specification Description Network Controller Chipset Broadcom® 5705KFB Bus Type PCI Bus Width 32 bits Bus Speed 33 or 66 MHz Standards Supported by ...

Specifications C-2 HP NC150T PCI 4-port Gigabit Combo Switch Adapter User Guide • • • UTP Cable Specifications For 1000BASE-T transmission, the cable must be: Category 5 UTP or better 22-26 AWG, 100 Ω @ 1MHz EIA/TIA 568a or EIA/TIA 568b Using UTP Category 5 Cable in Gigabit over Copper Installations...