HP B6R49AS#ABA - Manual

2 Setting Up the Monitor To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other attached devices, and then follow the instructions below. Extending the Monitor Stand 1. Lift the monitor from its box and place it face down on a flat surface. 2. Grasp the...

Connecting the Cables 1. Place the monitor in a convenient, well-ventilated location near the computer. Figure 2-3 Connecting the monitor 2. Connect one end of the DisplayPort signal cable (provided with select models) to the DisplayPort connector on the side of the monitor and the other end to the ...

Adjusting the Tilt Tilt the monitor's panel to set it to a comfortable eye level. Figure 2-5 Tilting the monitor VESA Adapter Plate The monitor includes a VESA 100 mm x 100 mm (3.9 in x 3.9 in) adapter plate. This can be used to attach the monitor panel to a VESA-compatible device (purchased separat...

Safety Information This product has not been evaluated for connection to an “IT” power system (an AC distribution system with no direct connection to the earth, according to IEC 60950). WARNING! Always disconnect the monitor from the power source before lifting, moving, or removing the stand from yo...

Installing the VESA Adapter Plate onto the Monitor NOTE: This apparatus is intended to be supported by a UL or CSA Listed wall-mount bracket. 1. Remove the stand from the monitor panel. Refer to Removing the Stand from the Monitor on page 7 . 2. Install the VESA adapter plate that shipped with the m...

b. Secure the lower edge of the VESA adapter plate to the bracket hinge with four screws. Figure 2-9 Securing the VESA adapter plate 3. To attach the monitor to a VESA-compatible device (purchased separately), follow the instructions included with that device to ensure that the monitor is safely att...

Replacing the Stand 1. Align the monitor stand over the bracket hinge and secure it with the four screws. Figure 2-12 Securing the monitor stand 2. Attach the hinge cover. Figure 2-13 Attaching the stand hinge cover 12 Chapter 2 Setting Up the Monitor

Turning on the Monitor 1. Press the power button on the front of the monitor to turn it on. 2. Press the power button on the computer to turn it on. CAUTION: Burn-in image damage may occur on monitors that display the same static image on the screen for a prolonged period of time (12 or more consecu...

3 Finding More Information Refer to the HP LCD Monitors Reference Guide included on the CD with your monitor for additional information on: ● Optimizing monitor performance ● Safety and maintenance guidelines ● Installing software from the CD ● Using the OSD menu ● Downloading software from the Web ...

A Technical Specifications NOTE: All specifications represent the typical specifications provided by HP component manufacturers; actual performance may vary either higher or lower. L2401x/x2401 Models Table A-1 L2401x/x2401 Specifications Display Type 60.96 cm MVA (Multi-domain Vertical Alignment 24...

Table A-1 L2401x/x2401 Specifications (continued) Altitude: Operating Storage 0 to 5,000 m 0 to 12,192 m 0 to 16,400 ft 0 to 40,000 ft Measured Power Consumption: Full Power Typical Settings Sleep Switch Off 28 W 23 W <0.5 W <0.5 W Input Terminal DisplayPort connector (cable includedwith selec...