HP A9P67UA - Manual

2 Networking (select models only) Your computer supports two types of Internet access: ● Wireless —Refer to Creating a wireless connection on page 2 . ● Wired —Refer to Connecting to a wired network on page 7 . NOTE: You must set up Internet service before you can connect to the Internet. Creating a...

Network (connected) Indicates that one or more network devices are connected to a network. Network (disconnected) Indicates that network devices are not connected to a network. Network (disabled/disconnected) Indicates that no wireless connections are available. Turning wireless devices on or off Yo...

Using operating system controls The Network and Sharing Center allows you to set up a connection or network, connect to a network,manage wireless networks, and diagnose and repair network problems. To use operating system controls: ▲ Select Start > Control Panel > Network and Internet > Net...

NOTE: Some cable modems include a built-in router. Check with your ISP to see if you need a separate router. The illustration below shows an example of a wireless network installation that is connected to theInternet. NOTE: When setting up a wireless connection, be sure that your computer and wirele...

generate a new key for every packet, and they also generate a different set of keys for eachcomputer network. To accomplish this: ◦ WPA uses Advanced Encryption Standard (AES) and Temporal Key Integrity Protocol(TKIP) ◦ WPA2 uses Cipher Block Chaining Message Authentication Code Protocol (CCMP), whi...

connect two or more computers to share the Internet through Bluetooth is a limitation of Bluetoothand the Windows operating system. Connecting to a wired network Using a modem (select models only) A modem must be connected to an analog telephone line using a 6-pin, RJ-11 modem cable(purchased separa...

3 Multimedia Your computer may include the following: ● One or two integrated speakers ● One or two integrated microphones ● Integrated webcam ● Preinstalled multimedia software ● Multimedia buttons or keys Using the media activity controls Depending on your computer model, you may have the followin...

Adjusting the volume Depending on your computer model, you can adjust the volume using the following: ● Volume buttons ● Volume hotkeys (specific keys pressed in combination with the fn key) ● Volume keys WARNING! To reduce the risk of personal injury, adjust the volume before putting on headphones,...

For information on how to access the webcam, refer to the Getting Started guide. For information on using the webcam, select Start > Help and Support . Video Your computer may have one or more of the following external video ports: ● VGA ● DisplayPort ● HDMI VGA The external monitor port, or VGA ...

▲ To connect a digital display device, connect the device cable to the DisplayPort. NOTE: For product-specific instructions on switching the screen image, refer to your Getting Started guide. HDMI The HDMI (High Definition Multimedia Interface) port connects the computer to an optional video oraudio...

NOTE: For product-specific instructions on switching the screen image, refer to your Getting Started guide. Configuring audio for HDMI To configure HDMI audio, first connect an audio or video device, such as a high-definition TV, to theHDMI port on your computer. Then configure the default audio pla...

4 Power management NOTE: A computer may have a power button or a power switch. The term power button is used throughout this guide to refer to both types of power controls. Shutting down the computer CAUTION: Unsaved information is lost when the computer shuts down. The Shut down command closes all ...

Setting power options Using power-saving states The computer has two power-saving states that are enabled at the factory: Sleep and Hibernation. When Sleep is initiated, the power lights blink and the screen clears. Your work is saved to memory,letting you exit Sleep faster than exiting Hibernation....

Customizing power plans To customize a power plan: 1. Click the power meter icon in the notification area, and then click More power options . – or – Select Start > Control Panel > System and Security > Power Options . 2. Select a power plan, and then click Change plan settings . 3. Change ...

Using battery power When a charged battery is in the computer and the computer is not plugged into external power, thecomputer runs on battery power. When the computer is plugged into external AC power, thecomputer runs on AC power. If the computer contains a charged battery and is running on extern...

Tips for maximizing battery discharge time: ● Lower the brightness on the display. ● Select the Power saver setting in Power Options. Managing low battery levels The information in this section describes the alerts and system responses set at the factory. Somelow-battery alerts and system responses ...

Resolving a low battery level when the computer cannot exit Hibernation When the computer lacks sufficient power to exit Hibernation, follow these steps: 1. Connect the AC adapter to the computer and to external power. 2. Exit Hibernation by pressing the power button. Conserving battery power ● Sele...

When you connect the computer to external AC power, the following events occur: ● The battery begins to charge. ● If the computer is turned on, the power meter icon in the notification area changes appearance. When you disconnect external AC power, the following events occur: ● The computer switches...

5 External cards and devices Using Digital Media Slot cards (select models only) Optional digital cards provide secure data storage and convenient data sharing. These cards areoften used with digital media–equipped cameras and PDAs as well as with other computers. To determine the digital card forma...

2. Pull the insert out of the slot (2) . To insert an ExpressCard: 1. Hold the card label-side up, with the connectors facing the computer. 2. Insert the card into the ExpressCard slot, and then press in on the card until it is firmly seated. You will hear a sound when the card has been detected, an...

Using smart cards (select models only) NOTE: The term smart card is used throughout this chapter to refer to both smart cards and Java™ Cards. A smart card is a credit card-sized accessory that carries a microchip containing memory and amicroprocessor. Like personal computers, some smart cards have ...

Removing a smart card ▲ Grasp the edge of the smart card, and then pull it out of the smart card reader. Using a USB device Universal Serial Bus (USB) is a hardware interface that can be used to connect an optional externaldevice, such as a USB keyboard, mouse, drive, printer, scanner, or hub. Some ...

NOTE: The first time you connect a USB device, a message in the notification area lets you know that the device is recognized by the computer. Removing a USB device CAUTION: To reduce the risk of damage to a USB connector, do not pull on the cable to remove the USB device. CAUTION: To reduce the ris...

Removing a 1394 device CAUTION: To reduce the risk of loss of information or an unresponsive system, stop the 1394 device before removing it. CAUTION: To reduce the risk of damage to a 1394 connector, do not pull on the cable to remove the 1394 device. 1. To remove a 1394 device, save your informati...

Removing an eSATA device CAUTION: To reduce the risk of damage to an eSATA connector, do not pull on the cable to remove the eSATA device. CAUTION: To reduce the risk of loss of information or an unresponsive system, use the following procedure to safely remove the device. 1. To remove an eSATA devi...

6 Drives Handling drives Drives are fragile computer components that must be handled with care. Refer to the followingcautions before handling drives. Additional cautions are included with the procedures to which theyapply. Observe these precautions: ● Before you move a computer that is connected to...

Using hard drives Improving hard drive performance Using Disk Defragmenter As you use the computer, files on the hard drive become fragmented. Disk Defragmenterconsolidates the fragmented files and folders on the hard drive so that the system can run moreefficiently. NOTE: It is not necessary to run...

Using HP ProtectSmart Hard Drive Protection software The HP ProtectSmart Hard Drive Protection software can be enabled or disabled by an Administrator. NOTE: Depending on your user privileges, you may be unable to enable or disable HP ProtectSmart Hard Drive Protection. Privileges for non-Administra...

5. Gently press the disc (3) down onto the tray spindle until the disc snaps into place. 6. Close the disc tray. NOTE: After you insert a disc, a short pause is normal. If you have not selected a media player, an AutoPlay dialog box opens. It prompts you to select how you want to use the media conte...

Sharing optical drives Although your computer may not have an integrated optical drive, you can access software and data,and install applications, by sharing an optical drive connected to another computer in your network.Sharing drives is a feature of the Windows operating system that allows a drive...

7 Security Protecting the computer Standard security features provided by the Windows® operating system and the non-Windows SetupUtility (BIOS) can protect your personal settings and data from a variety of risks. NOTE: Security solutions are designed to act as deterrents, but they may not deter soft...

NOTE: To reduce the risk of being locked out of the computer, record each password and store it in a secure place. You can use the same password for a Setup Utility (BIOS) feature and for a Windows securityfeature. You can also use the same password for more than one Setup Utility (BIOS) feature. Fo...

Managing a power-on password To set, change, or delete this password, follow these steps: 1. Open Setup Utility (BIOS) by turning on or restarting the computer. While the “Press the ESCkey for Startup Menu” message is displayed in the lower-left corner of the screen, press esc . When the Startup Men...

There are two types of firewalls to consider: ● Host-based firewalls—Software that protects only the computer it is installed on. ● Network-based firewalls—Installed between your DSL or cable modem and your home networkto protect all the computers on the network. When a firewall is installed on a sy...

3. Insert the cable lock into the security cable slot on the computer (3) , and then lock the cable lock with the key. 4. Remove the key and keep it in a safe place. Using the fingerprint reader (select models only) Integrated fingerprint readers are available on select computer models. In order to ...

8 Maintenance Cleaning your computer Cleaning the display CAUTION: To prevent permanent damage to the computer, never spray water, cleaning fluids, or chemicals on the display. To remove smudges and lint, frequently clean the display with a soft damp, lint-free cloth. If thescreen requires additiona...

Using SoftPaq Download Manager HP SoftPaq Download Manager (SDM) is a tool that provides quick access to SoftPaq informationwithout requiring the SoftPaq number. Using this tool, you can easily search for SoftPaqs, and thendownload and unpack them. SoftPaq Download Manager works by reading and downl...

9 Setup Utility (BIOS) and SystemDiagnostics Using Setup Utility (BIOS) Setup Utility, or Basic Input/Output System (BIOS), controls communication between all the input andoutput devices on the system (such as disk drives, display, keyboard, mouse, and printer). SetupUtility (BIOS) includes settings...

3. Use the arrow keys to select Exit > Load Setup Defaults . 4. Follow the on-screen instructions. 5. To save your changes and exit, press f10 , and then follow the on-screen instructions. – or – Use the arrow keys to select Exit > Exit Saving Changes , and then press enter . Your changes go i...

Using System Diagnostics System Diagnostics allows you to run diagnostic tests to determine if the computer hardware isfunctioning properly. Depending on your computer, the following diagnostic tests may be available inSystem Diagnostics: ● Start-up test—This test analyzes the main computer componen...

A Traveling with the computer For best results, follow these traveling and shipping tips: ● Prepare the computer for traveling or shipping: ◦ Back up your information. ◦ Remove all discs and all external media cards, such as digital cards. CAUTION: To reduce the risk of damage to the computer, damag...

B Troubleshooting resources ● Access Web site links and additional information about the computer through Help and Support.Select Start > Help and Support . NOTE: Some checkup and repair tools require an Internet connection. HP also provides additional tools that do not require an Internet connec...

C Electrostatic Discharge Electrostatic discharge is the release of static electricity when two objects come into contact—forexample, the shock you receive when you walk across the carpet and touch a metal door knob. A discharge of static electricity from fingers or other electrostatic conductors ma...

Index Symbols/Numerics 1394 cable, connecting 291394 devices connecting 29defined 29removing 30 A AC adapter, testing 23action keys media 11volume 12 administrator password creating 43entering 43managing 43 airport security devices 33antivirus software, using 44audio functions, checking 12 B battery...