Hotpoint RFA17 - Manual
Hotpoint RFA17 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – For Your Safety; For your safety, read the following advice:; If you sell the fridge freezer, pass on this booklet to the new owner.
- Page 3 – Installation; C, for prolonged periods. This is because; Minimum space required to open door
- Page 4 – Floor of the freezer compartment
- Page 5 – Electrical Supply; Earth
- Page 6 – Controls
- Page 7 – Useful Advice
- Page 8 – STORAGE ZONES; Cool
- Page 11 – Storing Food in a Freezer
- Page 13 – Defrosting; inch) Hotpoint recommend ‘fully defrosting your freezer’.; WARNING: Switch off electrical supply and pull out the mains plug.; Remove the storage drawers.
- Page 14 – Cleaning
- Page 15 – Note : Leave the doors ajar to prevent an accumulation of odours.; Changing the Light Bulb; Remove old bulb and fit new one.; Maintenance
- Page 16 – Remove the top hinge from the door.; Remove Lower Door; Note : You may require assistance to do this:; Door Reversal; Take the two screw
- Page 17 – Place the lower door onto the lower hinge pin.
- Page 18 – Troubleshooting
- Page 20 – Recycling & Disposal Information; Hotpoint guarantee; Disposal of old electrical appliances
- Page 21 – After Sales Service
- Page 22 – Notes
- Page 24 – Key Contacts; Repair Service and Information Help Desk; Extended Warranties; Genuine Parts and Accessories
Read the rest of these instructions to get the best from your appliance and
remember to fill in your guarantee registration.
GETTING STARTED:
To ensure that your fridge freezer runs reliably and efficiently follow these steps.
SAFET
Y &
INST
ALL
A
TION
C
ONTR
OLS
USEFUL AD
VICE
CLEANING &
MAINTENANCE
SER
VICE &
GU
AR
ANTEE
TR
OUBLESHOO
TING
Choose a location for your
fridge freezer, away from
any heat sources and
allow adequate
ventilation - 100mm
(4 inch) gap above.
Level the fridge freezer by
adjusting the front feet.
This will stop rocking or
vibration and keep the
door aligned.
Before plugging in and
switching on, leave the
fridge freezer in its final
location for at least 15
minutes to allow it to
settle.
Your fridge freezer is now
working.
If after 24 hours your
fridge freezer is not
operating as you want,
refer to the
TROUBLESHOOTING
section.
Move the fridge freezer
into position, using the
sides of the cabinet.
Take care to avoid
damaging the refrigerant
circuit pipe work on the
rear.
Plug in and switch on.
Allow the fridge freezer to
cool before placing food
inside.
All food in the fridge
freezer should be
covered.
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
Keep this Book in a safe place for quick reference.
NB. The spanner is for illustration
only and is not supplied with the
fridge freezer.
FRIDGE FREEZER - MODELS RFA17, RFM17, RFA16, RFM16
INSTRUCTIONS FOR INSTALLATION & USE
This appliance must not be installed in a location where the room temperature
drops below 10
o
C, or exceeds 32
o
C, for prolonged periods.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Was this manual helpful?
About this manual
- Brand
- Hotpoint
- Model
- RFA17
- Document type
- Manual
- Language(s)
- English
- Pages
- 24
- File size
- 1.1 MB
- Format
Summary
For Your Safety For your safety, read the following advice: The fridge freezer cooling system contains a small amount of gas which isenvironmentally friendly but flammable. To avoid any risk :- Install the fridge freezer following the installation instructions and ensure that ventilation openings ar...
Installation Location & Air CirculationWARNING: This appliance must not be installed in alocation where the room temperature drops below 10 o C, or exceeds 32 o C, for prolonged periods. This is because correct storage temperatures will not be maintained.Locate your fridge freezer away from sour...
Installation Levelling:Level the fridge freezer when it is in its final location by adjusting the front feet, untilfirm contact is made with the floor. This will stop rocking or vibration and keep thedoors aligned which helps the fridge freezer run reliably and efficiently. Note: Before plugging in ...
