Hotpoint RFA18 - Manual
Hotpoint RFA18 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – For Your Safety; For your safety, read the following advice:; If you sell the fridge freezer, pass on this booklet to the new owner.
- Page 3 – Installation; Minimum space required to open door
- Page 4 – To fit the bottle rack retainer:
- Page 5 – Electrical Supply; Earth
- Page 6 – Controls; Temperature Indicator (not applicable to all models)
- Page 7 – light will go out to show holiday mode is cancelled.
- Page 8 – Maximum freezing capacity in 24 hours:; Model; Load for freezing Pre-freeze time Load position
- Page 9 – Useful Advice
- Page 10 – STORAGE ZONES; Cool
- Page 13 – Storing Food in a Freezer
- Page 14 – For cleaning advice see CLEANING & MAINTENANCE section.
- Page 15 – Defrosting; inch) Hotpoint recommend ‘fully defrosting your freezer’.; WARNING: Switch off electrical supply and pull out the mains plug.; Remove the storage drawers.
- Page 16 – Cleaning
- Page 17 – Note : Leave the doors ajar to prevent an accumulation of odours.; Changing the Light Bulb; Remove old bulb and fit new one.; Maintenance
- Page 18 – Remove the top hinge from the door.; Remove Lower Door; Note : You may require assistance to do this:; Door Reversal; Take the two screw
- Page 19 – Place the lower door onto the lower hinge pin.
- Page 20 – Troubleshooting
- Page 22 – Recycling & Disposal Information; “Satisfac tion guaranteed or your money back”; Hotpoint guarantee; Disposal of old electrical appliances
- Page 23 – After Sales Service; Hotpoint appliance than us - the manufacturer”
- Page 24 – Indesit; Key Contacts; Repair Service and Information Help Desk; Extended Warranties; Genuine Parts and Accessories
FRIDGE FREEZER - MODELS RFA18, RFM18, RFA66, RFM66
INSTRUCTIONS FOR INSTALLATION & USE
GETTING STARTED:
To ensure that your fridge freezer runs reliably and efficiently follow these steps.
SAFET
Y &
INST
ALL
A
TION
C
ONTR
OLS
USEFUL AD
VICE
CLEANING &
MAINTENANCE
SER
VICE &
GU
AR
ANTEE
TR
OUBLESHOO
TING
Choose a location for your
fridge freezer, away from
any heat sources and
allow adequate
ventilation - 100mm
(4 inch) gap above.
Level the fridge freezer by
adjusting the front feet.
This will stop rocking or
vibration and keep the
door aligned.
Before plugging in and
switching on, leave the
fridge freezer in its final
location for at least 15
minutes to allow it to
settle.
If you are freezing fresh
food, turn on fast freeze
by pressing the switch 24
hours before placing the
food inside.
Place the fresh food
inside.
Move the fridge freezer
into position, using the
sides of the cabinet.
Take care to avoid
damaging the refrigerant
circuit pipe work on the
rear.
Plug in and switch on.
Allow the fridge freezer to
cool before placing food
inside.
The high temperature
light will stay on until the
fridge freezer has cooled
down.
All food in the fridge
freezer should be
covered.
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
Your fridge freezer is now
working.
If after 24 hours your
fridge freezer is not
operating as you want,
refer to the
TROUBLESHOOTING
section.
STEP 7
Read the rest of these instructions to get the best from your appliance and
remember to fill in your guarantee registration.
Keep this Book in a safe place for quick reference.
NB. The spanner is for illustration
only and is not supplied with the
fridge freezer.
Remember to turn fast freeze off
after 24 hours, however if you
forget to do so it will automatically
cancel after 48 hours.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Was this manual helpful?
About this manual
- Brand
- Hotpoint
- Model
- RFA18
- Document type
- Manual
- Language(s)
- English
- Pages
- 24
- File size
- 1.3 MB
- Format
Summary
For Your Safety For your safety, read the following advice: The fridge freezer cooling system contains a small amount of gas which isenvironmentally friendly but flammable. To avoid any risk :- Install the fridge freezer following the installation instructions and ensure that ventilation openings ar...
Installation Location & Air CirculationLocate your fridge freezer away from sources of heat e.g.cookers, radiators, direct sunlight as extreme temperaturewill affect its performance. Allow a minimum 100mm (4 inches) between the top ofthe fridge freezer and the ceiling or the underside of awall c...
Installation Levelling:Level the fridge freezer when it is in its final location by adjusting the front feet, untilfirm contact is made with the floor. This will stop rocking or vibration and keep thedoors aligned which helps the fridge freezer run reliably and efficiently. Note: Before plugging in ...