Hoover U5361950- Manual

Page 2 - Important Safeguards; Save these instructions!; Review this manual before

2 Thank you for choosing a HOOVER ® product. Please enter the COMPLETE model and serial numbers in the spaces provided.The numbers are located on the bottom of your cleaner. Model_________________________________________ Serial number_________________________________________ Hint: Attach your sales ...

Page 3 - If you need any assistance:; Visit our website at; Please do not return this product to the store.; Carton contents; Continued; Attach handle

3 1. Cleaner Assembly If you need any assistance: Visit our website at www.hoover.com . Click on the “Service” button to find the service outlet nearest you OR Call 1-800-944-9200 for an automated referral of service outlet locations (U.S. only) ORCall 1-330-499-9499 to speak with a representative i...

Page 5 - Cleaner description; Polarized plug

5 Continued ➜ 1. Handle2. Cord hooks: wrap cord around hooks for storage.The top hook rotates rightor left for easy cordrelease. 3. Hose4. ON/OFF switch: located on left rear corner ofcleaner body 5. Carrying handle6. Stair cleaning handle: located on lower edge ofdirt cup. 7. Handle release lever: ...

Page 6 - Carrying handle

Handle position For ease in sliding knob, place handlein the upright position (C). The nozzle will not move into theadjusted position until the cleanerhandle is lowered to the operatingposition (D). Settings For maximum cleaning performance, the following carpet height settings arerecommended. • Low...

Page 7 - Edge cleaning; Cleaning tools; How to clean tools; Select proper tool; Stair cleaning

7 Edge cleaning Edge cleaning is provided on both sidesof the nozzle to remove dirt in carpetnear baseboards and furniture. Guide either side of nozzle parallel toedge of carpet or furniture. Cleaning tools Tools allow for cleaning surfaces abovethe floor and for reaching hard to cleanareas. The cle...

Page 8 - Dirt cup; Attach wand and tools

3. Maintenance When to empty It is recommended that the dirt cup beemptied before the dirt reaches the dirtopening on back of dirt cup (Fig. 3-1) orafter every use if preferred. CAUTION: Very fine materials, suchas face powder or cornstarch, mayseal the filter and cause loss of suc-tion. When using ...

Page 9 - Filter assembly

9 3-10 3-6 3-5 3-7 3-8 3-9 3-11 Pull up on pre-filter assembly. Slide it outof cup. Replace dirt cup. Filter assembly How to clean filterassembly Remove dirt cup and dirt cup lid asdescribed in “How to empty dirt cup”. Pivot pre-filter assembly toward center ofcup. Remove main filter from pre-filter...

Page 10 - Cleaning secondary filter; Cleaning final filter; Check agitator shield; Headlight replacement; What to buy

G Remove lens - Disconnect clean- er from electrical outlet. Using a screwdriver, remove the twoscrews as shown and lift off lens. 3-16 3-15 10 Secondary and finalfilters Cleaning secondary filter Disconnect cleaner from electricaloutlet. The secondary filter (G) , located under- neath the retainer ...

Page 11 - How to replace; Belt replacement; When to replace

11 Continued ➜ 3-17 3-18 Remove agitator brush roll Remove agitator and used belt. Discard used belt. Replace lens - Reposition lens and secure with the two screws. How to replace Disconnect cleaner from electricaloutlet. Remove bottom plate Place handle in low position and turncleaner over so botto...

Page 12 - The agitator brush roll; Thermal protector

12 3-24 3-25 The agitator brush roll When to replace When agitator brushes are worn, theagitator should be replaced. To check condition of brushes, discon- nect cleaner from electrical outlet. Move edge of a card across bottomplate while turning agitator. To maintaincleaning effectiveness, replace a...

Table of Contents:

Other Manuals for Hoover U5361950

Summary

Other Hoover Models