Hobart UW50 ML-27838 - Manual

Page 2 - TABLE OF CONTENTS; Model UW50 Utensil

– 2 – ©HOBART, 2007 TABLE OF CONTENTS GENERAL ..............................................................................................................................................................3INSTALLATION .....................................................................................

Page 3 - SAVE THESE INSTRUCTIONS; GENERAL; INSTALLATION; UNPACKING; fl

– 3 – INSTALLATION, OPERATION AND CARE OF MODEL UW50 UTENSIL WASHER SAVE THESE INSTRUCTIONS GENERAL The UW50 Utensil Washer is the answer to volume utensil washing problems in your kitchen, bakery or supermarket operation. The UW50 occupies a minimum amount of fl oor space (under 48" x 43" w...

Page 5 - UW50 with Steam

– 5 – UW50 with Steam Tank Heat (Injector or Coil) with or without 14KW Electric Booster – Installation Diagram: D-812969 sheet 2

Page 6 - UW50 with Gas

– 6 – UW50 with Gas Tank Heat with or without 14KW Electric Booster – Installation Diagram: D-812969 sheet 3

Page 9 - of air

– 9 – RATE OF EXHAUST FLOW CALCULATIONS (FIG. 2) Based on the International Mechanical Code (latest edition). Fig. 2 Canopy size and location The inside lower edge of canopy-type Type I and II commercial hoods shall overhang or extend a horizontal distance of not less than 6 inches (152 mm) beyond t...

Page 11 - OPERATION; OFF

– 11 – Fig. 3 OPERATION CONTROLS (FIG. 3) P L - 5 6 3 5 1 OFF START POWER CYCLE 2 4 6 SELECTOR SWITCH FILL NOTE: Opening the door during cycles will cause cycle to start over at the beginning. DRAIN LEVER (Fig. 4)Drain lever is located inside the wash chamber (middle front with door open). Lower the...

Page 14 - MAINTENANCE; MOTOR; , rotate arms and remove any obstructions; DELIMING; Close

– 14 – MAINTENANCE Disconnect electrical power supply and follow lockout / tagout procedures. MOTOR The motor has permanently sealed bearings and requires no lubrication. WASH AND RINSE ARMS All wash arms and rinse arms should turn freely and continue turning for a few seconds after being whirled by...

Page 15 - TROUBLESHOOTING; SYMPTOM

– 15 – TROUBLESHOOTING SYMPTOM POSSIBLE CAUSE Utensils spotted or not clean Overloaded rack.Low water level.Water conditions:— Incorrect rinse water temperature. Refer to WATER SUPPLY CONNECTION, page 7. — Excessive water hardness may indicate that a water softener is needed. — Incorrect detergent t...

Hobart UW50 ML-27838 - Manual

Table of Contents:

Summary

Other Hobart Models