Hobart UW50 ML-27838 - Manuals

– 6 – UW50 with Gas Tank Heat with or without 14KW Electric Booster – Installation Diagram: D-812969 sheet 3

– 9 – RATE OF EXHAUST FLOW CALCULATIONS (FIG. 2) Based on the International Mechanical Code (latest edition). Fig. 2 Canopy size and location The inside lower edge of canopy-type Type I and II commercial hoods shall overhang or extend a horizontal distance of not less than 6 inches (152 mm) beyond t...

– 11 – Fig. 3 OPERATION CONTROLS (FIG. 3) P L - 5 6 3 5 1 OFF START POWER CYCLE 2 4 6 SELECTOR SWITCH FILL NOTE: Opening the door during cycles will cause cycle to start over at the beginning. DRAIN LEVER (Fig. 4)Drain lever is located inside the wash chamber (middle front with door open). Lower the...

– 14 – MAINTENANCE Disconnect electrical power supply and follow lockout / tagout procedures. MOTOR The motor has permanently sealed bearings and requires no lubrication. WASH AND RINSE ARMS All wash arms and rinse arms should turn freely and continue turning for a few seconds after being whirled by...

– 15 – TROUBLESHOOTING SYMPTOM POSSIBLE CAUSE Utensils spotted or not clean Overloaded rack.Low water level.Water conditions:— Incorrect rinse water temperature. Refer to WATER SUPPLY CONNECTION, page 7. — Excessive water hardness may indicate that a water softener is needed. — Incorrect detergent t...