Hobart UW50 - Manual
Hobart UW50 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
UW50 WAREWASHING
F-40057 (10/03)
1
Place strainer pan and scrap
basket into position in the
dishwasher tank.
2
Close the access door
(automatically closes drains).
3
Turn selector switch to FILL
and press start.
4
Open door to reset
and load utensils on
rack as necessary,
slide rack into
machine and close
the door.
5
Change selector to
desired wash cycle
length (2, 4, or 6
minutes).
6
Press START.
To Stop:
1
Open machine door.
2
Turn selector to OFF position.
1
Turn selector to OFF position.
2
Open machine door.
3
Lift drain lever inside door
opening.
4
Remove and clean strainer pan
and strainer basket.
5
Spray down machine interior.
6
Visually inspect top and bottom
wash and rinse arms, if
obstructed remove arms and
spray free with water.
7
Remove overflow tube and
wash thoroughly.
8
Inspect tank interior, remove
any soil from heater, probes,
and floats
9
Wipe down exterior with a wet
wash rag.
DO NOT SPRAY THE
EXTERIOR WITH A HOSE
10
Reassemble the machine:
a. Install scrap screen and
basket
b. Install wash and rinse
arms if removed
Leave door open at end of day
to allow interior to air out.
To Operate:
To Clean:
1
After placing wash and rinse arms back in the machine,
verify they all spin freely prior to operating the unit.
2
Delime the machine on a regular basis. This assures proper
function of the machine.
Note: Refer to “Troubleshooting”
section of your UW50 Instruction
Manual or call your local Hobart
Sales/Service office if you
experience any difficulties.
Operational Tips:
Hobart Corporation, 701 S. Ridge Avenue, Troy, OH 45374-0001
Phone: (937) 332-3000
www.hobartcorp.com
3
6
7
10
3
4
1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
