Hobart HCM62 - Manual
Hobart HCM62 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – HCM61 & HCM62 Food Processors; SAVE THESE INSTRUCTIONS; GENERAL; motor, is provided with 120 Volt cord and; motor, is provided with 208 - 240 Volt three; INSTALLATION; UNPACKING
- Page 3 – ELECTRICAL CONNECTIONS (Cord Connected Machines); Refer to the machine data plate and Electrical Data, below.; PRESTART CHECK
- Page 4 – BOWL AND KNIFE ASSEMBLY
- Page 5 – Cam on the Scraper
- Page 6 – OPERATION; switch is released, machine returns to OFF.
- Page 7 – motion to fully wipe the entire Bowl and lid.; USE OF THE FEED TUBE; turn. Remove the Scraper Handle. Separate
- Page 8 – TROUBLESHOOTING; SERVICE
N
S
T
R
U
C
T
I
O
N
S
I
HCM61 & HCM62 FOOD PROCESSORS
MODEL
HCM61
ML-134017
HCM62
ML-134018
7 0 1 S . R I D G E A V E N U E
T R O Y , O H I O 4 5 3 7 4 - 0 0 0 1
9 3 7 3 3 2 - 3 0 0 0
w w w . h o b a r t c o r p . c o m
F O R M 3 4 4 6 8 ( A p r . 2 0 0 0 )
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
– 2 – Installation, Operation, and Care of HCM61 & HCM62 Food Processors SAVE THESE INSTRUCTIONS GENERAL The model HCM61 and HCM62 Food Processors are used forchopping meat, fish, fruits, vegetables, nuts, or dry bread, formixing various sauces, mayonnaise, or soups, or for blending orpureeing v...
– 3 – ELECTRICAL CONNECTIONS (Cord Connected Machines) WARNING: THE ELECTRICAL CORD ON THIS MACHINE IS EQUIPPED WITH A GROUNDING TYPE PLUG WHICH MUST BE CONNECTED TO A PROPERLY GROUNDED RECEPTACLE. IF THERECEPTACLE IS NOT THE PROPER GROUNDING TYPE, CONTACT AN ELECTRICIAN. DO NOTREMOVE THE GROUNDING ...
– 4 – PL-41423-1 BOWL COVER BOWL COVER GASKET ALIGMENT PIN LIP LID PLUG PL-41421-1 ARM MOTOR SHAFT KNIFE SHAFT BOWL BOWL HANDLE BOWL PIN SLOT BOWL AND KNIFE ASSEMBLY Install the Bowl so the center post of the Bowl fitsover the motor shaft, one of the Bowl Pins fits inthe slot at the front of the mac...
