Henny Penny OGA-341 - Manual
Henny Penny OGA-341 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 7 – AND PROCEDURES
- Page 8 – The timing operation of the two sides of the control
- Page 9 – Special Programming is used to set the items below:
- Page 12 – AND; FILTER
- Page 14 – Scraping the electric fryer elements, or the burner; surfaces causing breading to stick and burn.; Figure
Model OFE/OFG/OEA/OGA-341, 342
3-1. OPERATING COMPONENTS
Reference Figure 3-1.
C1000
CONTROLS
Fig.
Item Description
Function
No. No.
3-1
1
Digital Display
Shows the shortening temperature, the timer countdown in
the Cook Cycle, and the selections in the Program Mode; the
temperature of the shortening can be shown by pressing
once, or twice to view set-point temperature;
if shortening temperature exceeds 425
°
F (218
°
C), the display
reads “E-5, FRYER TOO HOT”
3-1
2
This LED lights when the shortening temperature is within 5
°
of the setpoint temperature, signaling the operator that the
shortening temperature is now at the proper temperature for
dropping product into the frypot
3-1
3
The timer buttons are used to start and stop Cook Cycles
3-1
4
The idle buttons are used to start an Idle Mode which reduces
the temperature of the shortening during non-use periods;
press and hold to exit the Idle Mode
3-1
5
The program button is used to access the Program Modes;
also, once in the Program Mode, it is used to advance to the
next
parameter
3-1
6 & 7
Used to adjust the value of the currently displayed setting
in the Program Mode and to change set-point temperature for
the left frypot, or basket
3-1
8 & 9
Used to adjust the value of the currently displayed setting
in the Program Mode and to change set-point temperature for
the right frypot, or basket
Proceed onto Section 3-3, Filling or Adding Shortening
408
3-1
SECTION 3. OPERATION
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Model OFE/OFG/OEA/OGA-341, 342 The Computron 1000 controls are available on both split electronic controls frypot and full frypot fryers. The following is a brief description of the operating procedures for fryers with these controls. 1. Be sure the drain valve is in the closed position. 2. Place ba...
Model OFE/OFG/OEA/OGA-341, 342 Do not overload, or place product with extreme moisture content into the basket. 18 lbs. (8.2 kgs.) is the maximum amount of product per frypot. Failure to follow these directions can result in shortening overflowing the frypot. Serious burns or damage to the frypot co...
Model OFE/OFG/OEA/OGA-341, 342 Special Programming is used to set the items below: Fahrenheit or Celsius Initialize System Lock or Unlock Controls Fryer Type – Open or Pressure Heat Source – Electric; Gas w/standing pilot; Gas w/electronic ignition; Gas-Induced Draft Vat Type - Split or ...
