Havis-Shields P-REAR-2 - Manual
Havis-Shields P-REAR-2 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
P-REAR-2_INST_9-07
INSTALLATION INSTRUCTIONS P-REAR-2
REAR PARTITION w/ EXIT HATCH
1997-2008 FORD E-SERIES VANS
**WILL NOT WORK IN 2008 15 PASSENGER VAN (NO SPACE)**
TOOLS REQUIRED:
Power Drill
Drill Bit Set
Ratcheting Wrench
3/8” Socket Set
Eye Protection
HARDWARE:
QTY
DESCRIPTION
PART #
12
5/16” x 1 ½” Hex Head Lag Bolt
GSM33066
2
¼-20 x 1” Hex Head Bolt
GSM33002
2
¼” Flat Washer
GSM31005
2
¼-20 Serrated Nut
GSM30023
2
Top Mounting Brackets
HS-PA99008-1
1. INSTALLATION:
•
Rear passenger seat will remain in place. There is very little space between seat and rear
doors.
•
Place and position partition w/ spring clips facing towards rear of vehicle.
•
Partition must be pushed tight against seat in order to close doors.
•
Drill 3/16” pilot holes into floor of vehicle.
•
Bolt partition to vehicle using 5/16” x 1 ½” Hex head lag bolts.
•
Loosely bolt Top-mounting brackets to partition w/ (2) ¼-20 x 1” Hex Head bolt, washer,
and nut.
•
Mark and pre-drill 3/16” pilot where bracket lands on vehicles rear door trim. Attach
using (4) 5/16” x 1 ½” Hex head lag bolts.
•
Tighten all loose hardware
Top Mounting
Bracket Locations
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
