Havis-Shields P-MFK-9 - Manual
Havis-Shields P-MFK-9 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
P-REAR-1^MFK-9_INST_9-07
INSTALLATION INSTRUCTIONS
P-REAR-1 W/P-MFK-9
REAR PARTITION W/FILLER PANEL MOUNTING KIT
1997-2008 CHEVROLET PASSENGER VANS
Always
!
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
TOOLS REQUIRED
:
Power drill
Drill bit set
Standard socket set
Ratcheting wrench
COMPONENTS
:
QTY
DESCRIPTION
PART #
1 Partition
P-REAR-1
1
Mounting Filler Kit
P-MFK-9
P-MFK-9 COMPONENTS:
QTY
DESCRIPTION
1
Passenger Side Filler Panel
1
Driver Side Filler Panel
HARDWARE
:
QTY DESCRIPTION PART
#
5
¼” x 1 ½” Hex Head Lag bolts
GSM33062
2
¼” x 3” Hex Head Lag bolts
GSM33094
INSTALLATION:
•
Place and position partition with spring clips facing towards rear of vehicle.
•
Bottom frame of partition will be approximately 8 ½” from edge of door Frame.
•
Partition will contour trim just inside rear doors of vehicle.
•
Drill 3/16” pilot holes into floor of vehicle.
•
Loosely bolt partition to vehicle using ¼” x 1 ½” Hex head lag bolts.
•
Pre-drill top mounting holes with 3/16” bit. Attach to vehicle using ¼” x 3” Hex head
lag bolts.
•
Tighten all loose hardware
•
Install seat back to its original position
.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
