Havis-Shields F3 - Manual
Havis-Shields F3 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
WGI-F1-F2-F3-F4_INST_7-08
INSTALLATION INSTRUCTIONS WGI-F1, F2, F3, F4
INTERIOR WINDOW GUARDS
FOR 1994 – 2008 FORD WINDOW VANS
TOOLS REQUIRED:
Power Drill
1/8” Drill Bit
Phillips Screw Driver
Metric Socket set
Ratcheting Wrench
T-50 Torx Bit (for seat belts)
Plastic Cutting Tool (utility knife or tin snips)
HARDWARE:
QTY
DESCRIPTION
PART#
115
#10 x ½” Sheet metal screws
GSM34185
30
#10 X 1 ¼” Sheet metal screws
GSM33197
24
#10 Flat Washer
GSM31003
15
M4 x 7mm Hex nuts
GSM30200
24
½” Nylon spacers
GSM20095
2
Window Latch cover plate
WGI-F1-COVER PLATE
2
T-25 Torx ¼” Hex Insert OAL Tamperproof Bit
SM10260
SUBASSEMBLY:
1.
Remove seats and seat belts for better access to the windows.
2.
Remove plastic trim surrounding the fixed body windows. Save the plastic trim for
reinstallation.
3.
Determine which guard goes to each window. NOTE: The perforated diamond shaped holes has
one side that is smoother than the other. The smoother side goes towards the inside, facing the
passenger.
DOOR WINDOW GUARDS:
1.
In order for guard to fit properly on frame, you must permanently remove the upper plastic trim
on doors. The top of the lower door panel may have to be trimmed approximately ¼” to ½”.
(Note: Place guard on window frame to determine possible trimming).
See section 8 – door
window guard does not have cutouts for window latches (making them inoperable).
2.
With the doors open, hold the window screen up to the window/door frame. The guard
framework should fit evenly around the window frame.
3.
Mark a few holes at the top of the door frame using the predrilled holes on the screen framework
as a guide. Do not mark holes for the sides or bottom yet.
4.
Put on Safety goggles.
5.
Remove window guards and drill holes as marked with a 1/8” drill bit.
6.
Attach window screens by using #10 x ½” sheet metal screws. Now locate and mark the balance
of holes, drill and attach, starting at the top and work your way down.
7.
If vehicle has plastic upper door trim, do not reinstall.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
