Havis-Shields C-TM-IMP - Manual
Havis-Shields C-TM-IMP – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
TRAK-MOUNT ASSEMBLY
(Image Upside down)
INSTALL INSTRUCTIONS C-TM-IMP
2000-2005 CHEVROLET IMPALA TRAK-MOUNT KIT
TOOLS REQUIRED:
Ratcheting
Wrench
Metric Socket Set
Torx Bit Set
Standard Socket Set
Tape Measure
HARDWARE:
QTY DESCRIPTION PART#
8
¼” x ¾” hex head bolt
GSM33001
8 ¼”
Serrated
nut
GSM30023
6
¼” x 1” Hex head lag bolts
GSM33060
1
32” Trak mount
CM93055-9
SUB ASSEMBLY:
1. MOUNT TRAK TO HUMP BRACKETS.
•
Determine location that Trak will land on transmission hump for the specific
application.
•
With Trak in necessary location, measure Front and Rear Hump Brackets in relation
to Trak.
•
Bolt Trak to Hump Brackets, using measurements taken in previous step
Note: There are 2 different sides to the Trak Plate. It is recommended to mount Hump brackets
to side of Trak Plate that has ¼” hardware slots closer together, to better accept equipment,
(consoles, control heads, etc)
•
Slide (6) ¼-20 x ¾” Hex Head Bolts into ¼” Hardware Slots.
•
With bolts in Trak, position Hump brackets.
•
There is a left and right side to the Rear Hump Brackets. Top of brackets will be
parallel to the transmission hump.
•
Attach ¼” serrated nuts and tighten.
Front Hump Bracket C-B17
Rear Hump Bracket C-B27
Trak
¼” Hardware Slots
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
