Havis-Shields C-3619 - Manual
Havis-Shields C-3619 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Installation Instructions C-3619
MOTOROLA MW800/MW810 CPU TRUNK MOUNT
1995-2009 FORD CROWN VICTORIA
DRIVER SIDE TRUNK CPU BRACKET:
•
Remove driver side taillight.
•
Position CPU Mount bracket so holes in bracket line up w/ taillight
mounting holes.
•
Reattach taillight through holes in bracket, then loosely attach nuts.
•
Drill ¼” holes through vehicle trunk frame wall on opposite side of
bracket. Use front side of bracket as a drill guide.
•
Attach ¼-20 x ¾” Hex head bolts and ¼” Serrated nuts.
•
Tighten all hardware.
•
Mount CPU to Housing bracket using (4) 5mm-.8 x 10mm Hex
head machine screws and washers.
Be sure ON/OFF switch on
CPU is turned ON at this time.
•
This housing will be mounted to CPU Bracket after CPU cables
are attached and wiring is complete.
ATTACH CABLES TO CPU:
•
Data cable from monitor to Display 1.
•
Speaker cable box to port labeled AUX and Audio Out
•
Ignition sense cable attaches to Speaker cable box.
•
Route antenna cable to CPU
•
Attach antenna connector to antenna cable
•
Leave a service loop and wire tie antenna cable to CPU cover.
•
Now that all cable is attached and wiring is complete attach CPU
Housing to CPU bracket using pem-studs and ¼” serrated nuts
designated for the specific components.
•
CPU cables will face Rear Passenger Side taillight when mounted
then loop down and around computer, up the inner wheel well, to
the back seat wall.
•
CPU must be level, both vertically and horizontally, to meet
Motorola standards.
•
Place CPU cover (CM93625) on mount using 10-32 x ½” Machine
screw.
C-3619_INST_12-08
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
