Havis-Shields C-3190 - Manual
Havis-Shields C-3190 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
C
C-3190_INST_9-07
INSTALLATION INSTRUCTIONS
C-3190 SLIDE-OUT RADIO TRAY
1996-2008 FORD CROWN VICTORIA
Step 3.
Insert 2 (two) 1/4” x 1” hex
head cap screws in shelf holes.
Place bottom support bracket over
hex head cap screws, then place
hanger support bracket on top of
bottom bracket. Place 2 (two) 1/4"
flat washers and 2 (two) 1/4" flange
nuts. 1998 Crown Vic: use pair of
holes toward
front
of vehicle. For
1997 Crown Vic: use holes toward
rear of vehicle.
Step 4.
Using the support as a
template, mark and drill two holes in
upper deck. Bolt support bracket on
with 1/4” x 1” hex head cap screws,
2 (two) 1/4” flat washers, and 1/4”
flange nuts. Make sure shelf is
level and tighten all hardware.
Tools needed:
7/16” wrench and
socket, drill and 1/4” bit, level.
Hardware Included:
8 (eight) 1/4”
x 1” screws, 8 (eight) 1/4” flange
nuts, 8 (eight) 1/4” flat washers.
Note: Do not substitute hardware.
Do not use self-tapping screws as
they will vibrate loose.
Step 1.
Align forward radio shelf
bracket with existing holes in front
of trunk wall. Use 2 (two) 1/4” x 1”
hex head cap screws, 2 (two) 1/4”
flat washers and 2 (two) 1/4”
flange nuts. Don’t fully tighten
bracket yet.
Step 2.
Use a block of wood or a
shim to level radio shelf. Drill 1/4”
hole into trunk hinge, support base
on driver’s side. Fasten down shelf
using 1 (one) 1/4” x 1” hex head
cap screw, 1 (one) 1/4” flat
washer, and 1 (one) 1/4” flange
nut.
2
3
1
4
Back Seat
Wall
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
