Hand Held Products 4200 - Manual

IMAGETEAM™ 4200 Quick Start Guide 1 Getting Started IT4200 with Green LED AimerImager Identification

2 IMAGETEAM™ 4200 Quick Start Guide Reading Techniques The imager has a view finder that projects a bright red or green aiming beam that corresponds to the imager’s horizontal field of view. The aiming beam should be centered over the bar code, but it can be positioned in any direction for a good re...

IMAGETEAM™ 4200 Quick Start Guide 3 Connecting the Imager for USB A imager can be connected to the USB port of a computer. 1. Connect the appropriate interface cable to the imager. 2. Connect the other end of the cable to the computer. Note: The cable must be connected at the imager end (1) before t...

4 IMAGETEAM™ 4200 Quick Start Guide Connecting Imager for Keyboard Wedge (Powered by Host) A imager can be connected between the keyboard and PC as a “keyboard wedge.” The following is an example of a keyboard wedge connection: 1. Turn off power to the terminal/computer. 2. Disconnect the keyboard c...

6 IMAGETEAM™ 4200 Quick Start Guide Useful Menu Bar Codes Manual/Serial Trigger Mode Presentation Mode Suffix Selections Resetting the Standard Product Defaults Manual/Serial Trigger Presentation Mode Add CR Suffix Add CR, LF Suffix Add Tab Suffix Clear All Suffixes Standard Product Default Settings

IMAGETEAM™ 4200 Quick Start Guide 7 To Add a Test Code I.D. Prefix to All Symbologies Beeper and LED Sequences and Meaning Repairs User repairs and/or upgrades are not to be performed on this product. These services are to be performed only by an authorized service center. Maintenance The IT4200 pro...

8 IMAGETEAM™ 4200 Quick Start Guide The imager’s housing may also be cleaned the same way. Inspecting Cords and Connectors Inspect the imager’s interface cable and connector for wear or other signs of damage. A badly worn cable or damaged connector may interfere with imager operation. Contact your H...

IMAGETEAM™ 4200 Quick Start Guide 9 To Replace the IT4200 Interface Cable: 1. Turn the power to the host system OFF. 2. Disconnect the imager’s cable from the terminal or computer. 3. Locate the small hole on the side of the imager’s handle. This is the cable release. 4. Straighten one end of a pape...

10 IMAGETEAM™ 4200 Quick Start Guide You need to program a suffix. Programming a suffix enables the imager to output the bar code data plus the key you need (such as “CR”) to enter the data into your application. The imager won’t read your bar code at all. 1. Verify that your bar code symbology is e...

IMAGETEAM™ 4200 Quick Start Guide 11 Technical Support If you need assistance installing or troubleshooting your imager, please call your Distributor or your Hand Held Products, Inc. technical support office: Asia Pacific: Telephone: Int+852-3188-3485 or 2511-3050 E-mail: [email protected] ...

12 IMAGETEAM™ 4200 Quick Start Guide Patents Please refer to the product packaging for patent information. Solids and Water Protection The IT4200 has a rating of IP41, immunity of foreign particles and dripping water. Limited Warranty Hand Held Products, Inc., ("Hand Held Products, Inc.") wa...