Haier HB4200VA1M25, HB4800VA1M25, HB6000VA1M25, HB6000VC1M25 - Manual
Haier HB4200VA1M25, HB4800VA1M25, HB6000VA1M25, HB6000VC1M25 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INDEX; TOPIC; GENERAL
- Page 3 – PHYSICAL DIMENSIONS; A B C D E F G H J K
- Page 5 – AIR FLOW ORIENTATION
- Page 6 – HORIZONTAL LEFT-HAND INSTRUCTIONS; Important: Read instructions below carefully.; Secondary Knockout; Air flow
- Page 7 – DOWNFLOW INSTRUCTIONS; Important: Read instructions below carefully
- Page 8 – The evaporator
- Page 9 – installed; without
- Page 10 – THERMOSTAT WIRING
- Page 12 – ORIFICE CHANGE; WARNING; . No pressure loss indicates possible leak.; verify it is correct.; See piston kit chart in instructions.; AFTER THE TAILPIECE HAS COOLED,; position the white Teflon seal and hand; CIRCULATING AIR DUCT
- Page 13 – BLOWER PERFORMANCE; X temperature rise
- Page 14 – REGULAR MAINTENANCE; DISCONNECT ALL POWER SUPPLIES BEFORE PERFORMING ANY SERVICE.
10 to 12 SEER 3 to 5 Tons
HB3600VC1M25 HB4200VA1M25
Installation & Operation Manual
Air Handler
HB6000VA1M25 HB6000VC1M25
HB4800VA1M25
WARNING
WHEN THIS APPLIANCE IS INSTALLED IN AN ENCLOSED AREA, SUCH AS
A GARAGE OR UTILITY ROOM, WITH ANY CARBON MONOXIDE PRODUCING
DEVICES (i.e. AUTOMOBILE, SPACE HEATER, WATER HEATER,ETC.) INSURE
THAT THE ENCLOSED AREA IS PROPERLY VENTILATED.
WARNING
CARBON MONOXIDE (REFERED TO AS CO) CAN CAUSE PERSONAL INJURY
OR DEATH
WARNING
FAILURE TO FOLLOW THESE INSTRUCTIONS, LOCAL CODES OR NATIONAL
CODES MAY CAUSE FIRE, EXPLOSION, ELECTRICAL SHOCK, PERSONAL
INJURY OR PROPERTY DAMAGE.
FOLLOW ALL LOCAL CODES. IN THE ABSENCE OF LOCAL CODES REFER TO :
NATIONAL ELECTRICAL CODE NFPA 70
NFPA 90A & 90B
UNIFORM MECHANICAL CODE
READ THESE INSTRUCTIONS COMPLETELY BEFORE ATTEMPTING TO INSTALL
OR SERVICE THIS APPLIANCE.
ONLY FACTORY AUTHORIZED KITS OR ACCESSORIES SHOULD BE USED WHEN
INSTALLING OR MODIFYING THIS APPLIANCE, UNLESS OTHERWISE NOTED IN
THESE INSTRUCTIONS.
SOME LOCALITIES MAY REQUIRE THE INSTALLER/SERVICER TO BE LICENSED.
IF IN DOUBT CONTACT YOUR LOCAL AUTHORITIES.
These instructions should be retained and kept adjacent to the unit for future reference.
MODEL # HB 00VA1M25
MODEL # HB 00VC1M25
INSTALLATION DATE
The information contained in this booklet is subject to change without notice.
No. 0010575351
E
Models:
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
INDEX TOPIC PAGE GeneralPhysical dimensionsReplacement Parts SourceInstallation RequirementsAir Flow OrientationHorizontal Left-Hand InstructionsDownflow InstructionsRefrigerant TubingCondensate RemovalElectrical ConnectionsThermostat WiringOrifice ChangeCirculating Air DuctBlower PerformanceStart-u...
D C PRIMARY & SECONDARY CONDENSATE DRAINS- HORIZONTAL 3/4" NPT 2"[5.08 cm] 5.1"[13 cm] 2"[5.08 cm]TYPICAL F K G 1.1"[2.9 cm] 5"[12.7 cm] H 2.4"[ 6 cm] 1.2"[ 3 cm] INLETFRONT VIEW PRIMARY & SECONDARY CONDENSATE DRAINS- UPFLOW 3/4" NPT-FEMALE 1"[2.54cm] ...
AIR FLOW ORIENTATION Downflow discharge(with plastic verticalpan only) (see page 7) *Horizontal Right Discharge Tube and Drain conn. front Horizontal Left DischargeTube and Drain conn. front(see page 6) Important:Remove the horizontal pan whenunit is installed in unconditionedi.e. (Garage, Attic ) a...
