Haier GDZ5-1C- Manual

Dryer Timer: • Dryer Timer: The timer will let you set the time for up to 120 minutes to dry your clothes depending on the fabric type and load size. • Cotton/Synthetic Dry Button Setting: In order to dry COTTON clothes push button in its outward position. This means it is on HIGH HEAT setting. Inor...

11 English 1. Sort clothes for drying. Separate dark and light colored items, like you do for washing. Check for stains that have not been removed in washing. Dryerheat may permanently set some stains. Properly dried clothes will need minimum of care when removed from dryer. 2. Load up dryer with wa...

12 English Drying Tips Note: The average load will fill drum 1/3 to 1/2 full. Clothes will need room to tumble freely for even drying and less wrinkling. If you overload the dryer,you may cause damage to motor because it will not handle overloadsand the dryer may not start at all. You may have to re...

English 13 • Lint filter needs to be cleaned before and after each use for your unit to operate at optimum efficiency. The filter can be slid out, by pulling on the tablocated on the inside of the dryer door. The filter may be washed orvacummed. Remove the excess water from the filter by gently shak...

Dryer does not operate: • Check if unit is plugged in. The plug may have come loose.• Check if the electrical wall receptacle is of proper voltage. • Check if the circuit breaker needs to be reset or if the fuse needs to be replaced. • Check if the unit is in “Off” mode. Press Start button again.• C...

English 15 It is your responsibility • To connect a qualified electrical installer. • To be sure that the electrical connection is adequate and in conformance with CAN1-B149 (.1 or .2) installation codes and/or local codes. • A 4 wire, single phase, 115/230-volt, 60-Hz., AC-only electrical supply is...

Replacement Power Supply Cord must be: • UL Listed or CSA Interantional Certified • Marked for use with clothes dryers • Rated 115/230 volt minimum • 30 amp • Type SRD or SRDT • 4 Conductors • At least 5 ft (1.52 m) long. Grounding Instructions • For a grounded, cord-connected dryer:This dryer must ...

17 English • Select a suitable location for the dryer on a hard even surface away from direct sunlight or heat source e.g. radiators, baseboard heaters, cookingappliances etc. Any floor unevenness should be corrected with the levelinglegs located on the bottom of the dryer. 1. Remove all packaging m...

The following are specific requirements for proper and safe operation of your dryer. Failure to follow these instructions can cre- ate excessive drying times and fire hazards. WARNING 1. Do not use plastic flexible duct to exhaust the dryer. Excessive lint can build up inside exhaust system and crea...

19 English Materials INSTALL MALE FITTINGS IN THE CORRECT DIRECTION Use only 4 inch (10.2 cm) diameter (minimum) rigid or flexible metal duct andapproved vent hood which has a swing-out damper hat open when the dryer isin operation. When the dryer stops, the dampers automatically close to preventdra...

21 English Do Not Install Your Dryer: • In an area exposed to dripping water or outside weather conditions. • In an area where it will come in contact with curtains, drapes, or anything that will obstruct the flow of combustion and ventilation air. • On carpet. Floor must be solid with a maximum slo...

English • Dryer must be exhausted outside (outdoors, not beneath the mobile home) using metal ducting that will not support combustion. Metal ducting must be 4 inches (10.16 cm) in diameter with no obstructions. Rigid metal duct is preferred. • If dryer is exhausted through the floor and area beneat...

Made in China Fabriqué en Chine Haier America New York, NY 10018 Printed in China GDZ5-1C-01Issued: April 05 IMPORTANT Do Not Return This Product To The Store If you have a problem with this product, please contact the "Haier Customer Satisfaction Center" at 1-877-337-3639. DATED PROOF OF PU...