Grizzly Industrial T24631 - Manual

The Model T24631 spiral cutterhead is designed
to replace the straight-knife cutterhead on the
Model G0656/G0656P 8" Jointer.

CoPyriGhT © JULy, 2012 By GrizzLy indUsTriaL, inC.

Warning: no portion of this manual may be reproduced in any shape

or form Without the Written approval of grizzly industrial, inc.

#Tr15167 PrinTed in China

items needed for installation

Wrench 14mm ................................................... 1
Wrench 17mm.................................................... 1
socket driver 1/4" .............................................. 1
Precision straightedge ..................................... 1
Feeler Gauge set (sizes not important) ............ 1
Pulley Puller ....................................................... 1
Pair of heavy Leather Gloves ........................... 1
rubber dead Blow hammer ............................. 1
2x4 Wood Block 4" Long ................................... 1

inventory

(

figure 2)

a. spiral Cutterhead w/inserts ........................ 1

b. Torx drivers T20 ........................................ 2

c. Torx L-Wrenches T20 ................................ 2

d. Flat head Torx screws T20 M6-1 x 15 ...... 3

e. indexable Carbide inserts 14 x 14 x 2 ....... 5

figure 2.

spiral cutterhead inventory.

C

d

B

a

e

For questions or help with this product contact Tech Support at (570) 546-9663 or [email protected]

model t24631

8" spiral cutterhead

installation instructions

introduction

figure 1. T24631 spiral Cutterhead.

it takes approximately one hour to install this
cutterhead and re-adjust the jointer. The job con-
sists of (1) removing the old cutterhead, (2) install-
ing/shimming the new spiral cutterhead, and (3)
re-adjusting the outfeed table to be even with the
carbide inserts at TdC (top dead center).

note: We strongly recommend replacing the

old cutterhead bearings during installation.

recommended, but not required

inch/Pound Torque Wrench. .............................. 1
arbor Press ....................................................... 1
Ball Bearing 6204zz .......................................... 1
Ball Bearing 6203zz ......................................... 1

specifications

Length ............................................................... 8"
diameter ........................................................... 3"
number of spirals .............................................. 4
number of inserts ............................................ 40
insert size .................................... 14 x 14 x 2mm
insert screw Thread size ......................... M6-1.0
shaft diameter (Long side) ....................... 20mm
shaft diameter (short side) .......................17mm
Weight .......................................................18 lbs.