Grizzly Industrial T10114 - Manual
Grizzly Industrial T10114 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
MODEL T10114
HEAVY-DUTY
ROLLER STAND
INSTRUCTIONS
Introduction
The Model T10114 Heavy-Duty Roller Stand is
vertically adjustable from 26
1
⁄
4
" to 41" with the
use of a crank handle and the attached elevation
gears, as shown in
Figure 1
.
Inventory
After removing the contents of the shipping
package, lay them out and refer to the
Parts
Breakdown
on the back page to inventory the
components.
If you need help with your new roller stand, call
our Tech Support at: (570) 546-9663.
Assembly
Refer to
Figure 1
and the
Parts Breakdown
illus-
tration to aid you during assembly.
Tools Needed
Qty
Phillips Screwdriver ........................................... 1
Hex Wrench 3mm .............................................. 1
Wrench or Socket 10, 13mm .................... 1 Each
To assemble your roller stand:
1.
Thread the four foot pads into the base.
2.
Secure the bottom vertical support onto the
base by threading the
3
⁄
8
"-16 x 1" hex bolt,
lock washers, and flat washers through the
bottom of the base and into the support.
3.
Insert the top vertical support into the bottom
support with the horizontal slits facing toward
the gear assembly mounting.
4.
Position the elevation gearbox onto its mount-
ing point and make sure the gear teeth mesh
with the slits in the top vertical support, then
secure the gearbox with the four
1
⁄
4
"-20 x
1
⁄
2
"
Phillips head screws.
5.
Align the set screw in the crank handle hub
with the flat of the gear assembly shaft, slide
the crank onto the shaft, then tighten the set
screw to secure it in place.
6.
Thread the two lock knobs into the holes on
the side of the bottom support.
7.
Attach the roller bracket to the top verti-
cal support with the four
1
⁄
4
"-20 x
1
⁄
2
" flange
bolts.
8.
Insert one side of the roller axle into a mount-
ing hole on the roller bracket, then push in on
the other end of the spring-loaded axle until
you can insert it into the remaining mounting
hole.
Figure 1.
Model T10114 identification.
Roller
Lock
Knob
Adjustable Foot Pad
Elevation
Gearbox
Crank
Handle
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
