Grizzly Industrial H7679 - Manual

H7679 2" Nailer Kit -4 - INTRODUCTION If you have any comments regarding this manual, please write to us at the following address: Grizzly Industrial, Inc. C/O Technical Documentation Manager P.O. Box 2069 Bellingham, WA 98227-2069 Most importantly, we stand behind our tools. If you have any ser...

H7679 2" Nailer Kit -5 - SET UP Figure 1. Model H7679 inventory. Unpacking Your Model H7679 left our warehouse in a carefully packed box. If you discover the nailer is damaged after you have signed for delivery, please immediately call Customer Service at (570) 546-9663 for advice. Save the cont...

H7679 2" Nailer Kit -8 - OPERATIONS Loading Figure 3. Sliding magazine pusher back and locking catch lever in place. When replacing nails in your Model H7679, follow these guidelines: Gauge: 18Length: 3 ⁄ 8 " – 2" Capacity: 100 To load your nailer: 1. DISCONNECT NAILER FROM THE AIR SUPPL...

H7679 2" Nailer Kit -9 - Figure 6. Depth adjustment controls. A depth adjustment knob is attached to the nose for setting the nail depth. To adjust the depth: 1. DISCONNECT NAILER FROM THE AIR SUPPLY! 2. Rotate the adjustment knob ( Figure 6 ) clockwise to drive the nails deeper or counterclockw...

H7679 2" Nailer Kit -10 - A jammed nail must be cleared before using the nailer again. To clear a jammed nail from the dis-charge area: 1. DISCONNECT NAILER FROM THE AIR SUPPLY! 2. Unlatch and pull the magazine all the way back. 3. Remove the nail stick from the maga- zine. Clearing Jammed Nails...

H7679 2" Nailer Kit -11 - Replacing Pistons /O- Rings If you use your nailer day in and day out, repair pistons are cheap insurance against wasted down time and lost profits, in the event that a piston or piston shaft becomes worn out. The piston repair kit part number for the Model H7679 is # P...

H7679 2" Nailer Kit -12 - CLEANING & LUBRICATION Cleaning Use a good solvent to clean the nose assembly of the nailer. Always be sure that the nailer is dry before using it again. Do not allow dust, chips, sand, etc. into the air connectors or into the body of the nailer; this may result in ...

H7679 2" Nailer Kit -15 - TROUBLESHOOTING Symptom Possible Cause Solution Air leaking at trig-ger valve area. 1. O-rings in trigger valve hous- ing are damaged. 1. O-rings must be replaced & operation of safety nose must be checked. Air leaking between housing and hose. 1. Loose screws in ho...

Grizzly Industrial, Inc. warrants every product it sells for a period of 1 year to the original purchaser from the date of purchase. This warranty does not apply to defects due directly or indirectly to misuse, abuse, negligence, accidents, repairs or alterations or lack of maintenance. This is Griz...

WARRANTY CARD Name _________________________________________________________________Street _________________________________________________________________City _______________________ State _________________________ Zip _________Phone # ____________________ Email ________________________ Invoice # ...

FOLD ALONG DOTTED LINE GRIZZLY INDUSTRIAL, INC.P.O. BOX 2069BELLINGHAM, WA 98227-2069 TAPE ALONG EDGES--PLEASE DO NOT STAPLE Name________________________________ Street________________________________ City______________State______Zip_______ Send a Grizzly Catalog to a friend: Place Stamp Here