Grizzly Industrial H7664 - Manual

H7664 2-in-1 Combination Nailer/Stapler -8 - SECTION 2: INTRODUCTION If you have any comments regarding this manual, please write to us at the following address: Grizzly Industrial, Inc. C/O Technical Documentation Manager P.O. Box 2069 Bellingham, WA 98227-2069 Most importantly, we stand behind our...

H7664 2-in-1 Combination Nailer/Stapler -9 - SECTION 3: SET UP Figure 1. Model H7664 inventory. Unpacking Your Model H7664 left our warehouse in a carefully packed box. If you discover the nailer/stapler is damaged after you have signed for delivery, please immediately call Customer Service at (570)...

H7664 2-in-1 Combination Nailer/Stapler -11 - Safety Yoke A safety yoke mechanism on the nose of the nailer/stapler acts as a safety device. When the trigger is pressed, the nailer/stapler will not fire until the safety yoke mechanism is depressed. Before you use your nailer/stapler for the first ti...

H7664 2-in-1 Combination Nailer/Stapler -12 - SECTION 4: OPERATIONS Loading Figure 3. Catch lever engaged and magazine pusher retracted. When replacing brads or staples in your Model H7664, follow these guidelines: Gauge: 18Brad Length: 5 ⁄ 8 "-2" Staple Length: 5 ⁄ 8 "-1 5 ⁄ 8 " (cr...

H7664 2-in-1 Combination Nailer/Stapler -13 - 5. Pull the trigger. — If the nail/staple drove into the wood far enough, continue with your intended operations. — If the nail/staple either went too far or not far enough, then go to the Adjusting Depth sub-section on this page. 2. To test for proper n...

H7664 2-in-1 Combination Nailer/Stapler -15 - Figure 7. Opening cover to clear a jam. To clear a jammed nail from the dis-charge area: 1. DISCONNECT NAILER/STAPLER FROM THE AIR SUPPLY! 2. Unlock the catch lever and pull the magazine pusher back completely. 3. Remove the nail/staple stick from the ma...

H7664 2-in-1 Combination Nailer/Stapler -17 - SECTION 5: MAINTENANCE Cleaning Disconnect the nailer/stapler from the air supply before cleaning. Use a good solvent to clean the nose assembly of the nailer/stapler. Always be sure that the nailer/stapler is dry before using it again. Do not allow dust...

H7664 2-in-1 Combination Nailer/Stapler -18 - Troubleshooting Symptom Possible Cause Solution Air leaking at trig-ger valve area. 1. O-rings in trigger valve hous- ing are damaged. 1. O-rings must be replaced & operation of safety yoke must be checked. Air leaking between housing and hose. 1. Lo...

Grizzly Industrial, Inc. warrants every product it sells for a period of 1 year to the original purchaser from the date of purchase. This warranty does not apply to defects due directly or indirectly to misuse, abuse, negligence, accidents, repairs or alterations or lack of maintenance. This is Griz...

WARRANTY CARD Name _________________________________________________________________Street _________________________________________________________________City _______________________ State _________________________ Zip _________Phone # ____________________ Email ________________________ Invoice # ...

FOLD ALONG DOTTED LINE GRIZZLY INDUSTRIAL, INC.P.O. BOX 2069BELLINGHAM, WA 98227-2069 TAPE ALONG EDGES--PLEASE DO NOT STAPLE Name________________________________ Street________________________________ City______________State______Zip_______ Send a Grizzly Catalog to a friend: Place Stamp Here