Grizzly Industrial H6332 - Manual

H6332 1 1 ⁄ 4 " Brad Nailer -4 - INTRODUCTION If you have any comments regarding this manual, please write to us at the following address: Grizzly Industrial, Inc. C/O Technical Documentation Manager P.O. Box 2069 Bellingham, WA 98227-2069 Most importantly, we stand behind our tools. If you have...

H6332 1 1 ⁄ 4 " Brad Nailer -5 - SET UP Figure 1. Model H6332 inventory. Unpacking Your Model H6332 left our warehouse in a carefully packed box. If you discover the nailer is damaged after you have signed for delivery, please immediately call Customer Service at (570) 546-9663 for advice. Save ...

H6332 1 1 ⁄ 4 " Brad Nailer -8 - OPERATIONS Loading Figure 3. Releasing catch lever and sliding magazine pusher back. When replacing nails in your Model H6332, follow these guidelines: Gauge: 18Length: 3 / 8 " – 1 1 ⁄ 4 " Capacity: 100 To load your nailer: 1. DISCONNECT NAILER FROM THE A...

H6332 1 1 ⁄ 4 " Brad Nailer -9 - 5. Pull the trigger. — If the nail drove into the wood far enough, continue with your intended operations. — If the nail either went too far or not far enough, then go to the Adjusting Depth section on this page. 3. Depress the safety nose mechanism against your ...

H6332 1 1 ⁄ 4 " Brad Nailer -10 - 4. Open the nailer nose by removing the rubber nose tip, depressing the nose release mechanism, and opening the nose cover as shown in Figure 7 . Clearing Jammed Nails 5. Dislodge the jammed nail with a tool that will fit in the slot on the underside of the nose...

H6332 1 1 ⁄ 4 " Brad Nailer -11 - Replacing Pistons /O- Rings If you use your nailer day in and day out, repair pistons are cheap insurance against wasted down time and lost profits, in the event that a piston or piston shaft becomes worn out. A replacement piston and O-ring kit, part PH6332082,...

H6332 1 1 ⁄ 4 " Brad Nailer -12 - CLEANING & LUBRICATION Cleaning Use a good solvent to clean the nose assembly of the nailer. Always be sure that the nailer is dry before using it again. Do not allow dust, chips, sand, etc. into the air connectors or into the body of the nailer; this may re...

H6332 1 1 ⁄ 4 " Brad Nailer -13 - TROUBLESHOOTING Symptom Possible Cause Solution Air leaking at trigger valve area. 1. O-rings in trigger valve hous- ing are damaged. 1. O-rings must be replaced & operation of safety nose must be checked. Air leaking between hous-ing and hose. 1. Loose scre...

Grizzly Industrial, Inc. warrants every product it sells for a period of 1 year to the original purchaser from the date of purchase. This warranty does not apply to defects due directly or indirectly to misuse, abuse, negligence, accidents, repairs or alterations or lack of maintenance. This is Griz...

WARRANTY CARD Name _________________________________________________________________Street _________________________________________________________________City _______________________ State _________________________ Zip _________Phone # ____________________ Email ________________________ Invoice # ...

FOLD ALONG DOTTED LINE GRIZZLY INDUSTRIAL, INC.P.O. BOX 2069BELLINGHAM, WA 98227-2069 TAPE ALONG EDGES--PLEASE DO NOT STAPLE Name________________________________ Street________________________________ City______________State______Zip_______ Send a Grizzly Catalog to a friend: Place Stamp Here