Grizzly Industrial H6143 - Manual

H6143 16 Ga. Finish Nailer -4 - INTRODUCTION If you have any comments regarding this manual, please write to us at the following address: Grizzly Industrial, Inc. C/O Technical Documentation Manager P.O. Box 2069 Bellingham, WA 98227-2069 Most importantly, we stand behind our tools. If you have any ...

H6143 16 Ga. Finish Nailer -5 - SET UP Figure 1. Model H6143 inventory. Unpacking Your Model H6143 left our warehouse in a carefully packed box. If you discover the nailer is damaged after you have signed for delivery, please immediately call Customer Service at (570) 546-9663 for advice. Save the c...

H6143 16 Ga. Finish Nailer -8 - OPERATIONS Loading Figure 3. Sliding magazine pusher back and engaging catch lever. When replacing nails in your Model H6143, follow these guidelines: Gauge: 16Length: 1 1 ⁄ 4 " – 2 1 ⁄ 2 " Capacity: 74 To load your nailer: 1. DISCONNECT NAILER FROM THE AIR SU...

H6143 16 Ga. Finish Nailer -9 - Figure 6. Depth adjustment controls. A depth adjustment knob is attached to the nose for setting the nail depth. To adjust the depth: 1. DISCONNECT NAILER FROM THE AIR SUPPLY! 2. Rotate the adjustment knob ( Figure 6 ) clockwise to drive the nails deeper or counterclo...

H6143 16 Ga. Finish Nailer -11 - Replacing Pistons /O- Rings If you use your nailer day in and day out, repair pistons are cheap insurance against wasted down time and lost profits, in the event that a piston or piston shaft becomes worn out. For your convenience, refer to the parts breakdown during...

H6143 16 Ga. Finish Nailer -12 - CLEANING & LUBRICATION Cleaning Use a good solvent to clean the nose assembly of the nailer. Always be sure that the nailer is dry before using it again. Do not allow dust, chips, sand, etc. into the air connectors or into the body of the nailer; this may result ...

H6143 16 Ga. Finish Nailer -15 - TROUBLESHOOTING Symptom Possible Cause Solution Air leaking at trig-ger valve area. 1. O-rings in trigger valve hous- ing are damaged. 1. O-rings must be replaced & operation of safety nose must be checked. Air leaking between housing and hose. 1. Loose screws in...

Grizzly Industrial, Inc. warrants every product it sells for a period of 1 year to the original purchaser from the date of purchase. This warranty does not apply to defects due directly or indirectly to misuse, abuse, negligence, accidents, repairs or alterations or lack of maintenance. This is Griz...

WARRANTY CARD Name _________________________________________________________________Street _________________________________________________________________City _______________________ State _________________________ Zip _________Phone # ____________________ Email ________________________ Invoice # ...

FOLD ALONG DOTTED LINE GRIZZLY INDUSTRIAL, INC.P.O. BOX 2069BELLINGHAM, WA 98227-2069 TAPE ALONG EDGES--PLEASE DO NOT STAPLE Name________________________________ Street________________________________ City______________State______Zip_______ Send a Grizzly Catalog to a friend: Place Stamp Here