Grizzly Industrial H5527 - Manual

H5527 18 Gauge Brad Nailer -7 - The Model H5527 is designed to be oper-ated at 60-100 PSI using clean, dry, regu-lated, compressed air. DO NOT exceed the 120 PSI maximum operating pres-sure for your model. Before using your new nailer, regulate the air pressure on your air compressor to the minimum ...

H5527 18 Gauge Brad Nailer -8 - A safety mechanism on the nose of the nailer protects against accidental firing. When the trigger is pressed, the nailer will not fire until the safety nose mechanism is depressed. Before you use your nailer for the first time, check the safety nose mechanism to ensur...

H5527 18 Gauge Brad Nailer -9 - OPERATIONS Loading When replacing nails in your Model H5527, follow these guidelines: Gauge: 18Length: 5 ⁄ 8 " – 2" Capacity: 100 To load your nailer: 1. DISCONNECT NAILER FROM THE AIR SUPPLY! 2. Grip the nailer firmly, and depress the magazine latch, as shown...

H5527 18 Gauge Brad Nailer -10 - 5. Pull the trigger. — If the nail drove into the wood far enough, continue with your intended operations. — If the nail either went too far or not far enough, then adjust the air pres-sure. More air pressure will make the nail go deeper and less air pres-sure will d...

H5527 18 Gauge Brad Nailer -12 - Replacing Pistons /O- Rings If you use your nailer day in and day out, repair pistons are cheap insurance against wasted down time and lost profits, in the event that a piston or piston shaft becomes worn out. 6. Open the nose cover as if to clear a jammed nail. 7. W...

H5527 18 Gauge Brad Nailer -13 - ACCESSORIES G2820 —Pneumatic Tool Oil 8 oz.G2821—Pneumatic Tool Oil 1 Pint Use the right oil! This pneumatic tool oil offers outstanding heat displacement and friction reduction without eating away at delicate air components like detergent motor oils. Stock up with e...

H5527 18 Gauge Brad Nailer -14 - CLEANING & LUBRICATION Cleaning Use a good solvent to clean the nose assembly of the nailer. Always be sure that the nailer is dry before using it again. Do not allow dust, chips, sand, etc. into the air connectors or into the body of the nailer; this may result ...

H5527 18 Gauge Brad Nailer -17 - TROUBLESHOOTING Symptom Possible Cause Solution Air leaking at trig-ger valve area. 1. O-rings in trigger valve hous- ing are damaged. 1. O-rings must be replaced & operation of safety nose must be checked. Air leaking between housing and hose. 1. Loose screws in...

Grizzly Industrial, Inc. warrants every product it sells for a period of 1 year to the original purchaser from the date of purchase. This warranty does not apply to defects due directly or indirectly to misuse, abuse, negligence, accidents, repairs or alterations or lack of mainte-nance. This is Gri...