Grizzly Industrial G8720 - Manual
Grizzly Industrial G8720 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Raising a Load; Lowering a Load
- Page 3 – Maintenance
- Page 4 – parts breakdown
MODEL G8720
3
1
⁄
2
TON
HIGH LIFTING JACK
INSTRUCTIONS
Copyright © oCtoBEr, 2008 By grizzly industrial, inC.
WARNING: NO pORTION OF THIS MANUAL MAy bE REpRODUCED IN ANy SHApE
OR FORM WITHOUT THE WRITTEN AppROvAL OF GRIzzLy INDUSTRIAL, INC.
#ts11148 printEd in China
To reduce the risk of serious injury when
using this jack:
1. Only use this jack for lifting and do not
exceed the design specifications.
2. DO NOT alter any part of this jack
or use it for any purpose it was not
designed for.
3. DO NOT lift vehicles with curved or
tubular bumpers that will slip off the
lifting nose. Always position the lifting
nose under a flat, stable part of the
vehicle that will safely handle the load.
4. Always stabilize and chock the load
before positioning the jack underneath
it.
5. Make sure the base of the jack is on a
flat, solid surface that can hold the load
and that will not allow the jack base to
slip.
6. NEvER place any part of your body
under a load lifted by this jack.
7. DO NOT push the load off the jack.
Lower the load slowly and carefully and
make sure all bystanders are clear of
the load.
8. DO NOT use extension devices on the
jack handle.
Specifications
Max. lifting load ......... 3
1
⁄
2
u.s. tons (7000 lbs.)
required Minimum lifting load .............. 110 lbs.
Maximum lifting height .................................. 48"
Overview
the Model g8720 3-1/2 ton high lifting Jack
is designed to lift a load higher than the typical
automobile jack. the lifting assembly "walks" the
lifting nose along the jack bar using two climbing
pins that move in and out of the holes on the bar
as the jack handle is raised and lowered.
Figure 1. Model g8720 identification.
Jack handle
Jack Base
Jack Bar
lifting nose
& assembly
top
Connecting
plate
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
-2- g8720 3 1 ⁄ 2 ton high lifting Jack Raising a Load 1. read and follow all warning instructions on page 1. 2. stabilize and chock the load. 3. place the jack base directly under the intend- ed contact point of the jack lifting nose and the load, with the jack bar straight up and down. 4. raise th...
g8720 3 1 ⁄ 2 ton high lifting Jack -3- Maintenance the jack may bind if the holes in the jack bar are clogged or if the moving parts of the jack are dirty, rusty, or without lubrication. always keep your jack in good condition and perform regular maintenance as described below to ensure safe and ef...
-4- g8720 3 1 ⁄ 2 ton high lifting Jack parts breakdown & ' ( ) * + , - . &% && &' &( &) &* &+ &, &- &. '% REF PART # DESCRIPTION REF PART # DESCRIPTION 1 P8720001 TOP CLAMP-CLEVIS BOLT 11 P8720011 BASE 2 P8720002 TOP CLAMP-CLEVIS 12 P8720012 CLIMBING ...
