Grindmaster 87710 - Manual
Grindmaster 87710 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – American Metal Ware 87710E Coffee Urn; General Description; brew cycle or, if desired, manually at any time with a push button.
- Page 4 – Installation
- Page 5 – Timer Adjustment
- Page 6 – How To Brew In An Automatic Urn; Explanation Of Brewing Cycle
- Page 7 – Thermostat; Thermostat Adjustment
- Page 8 – Care and Cleaning of Coffee Urn; Semi-Weekly Cleaning Procedure; NOTE: Coffee system cleaners that have been used successfully:
- Page 9 – Solid State Coffee Agitation System; Automatic Program - End of Brew and Delayed Types; Page 10
- Page 10 – Operation Malfunction and Service
- Page 11 – Dual Level Control Auto Refill And Low Water Cutoff System; Description and Operation of the Dual Level Control System:; Page 12
- Page 16 – Service/Troubleshooting Solid State Air Agitation
- Page 17 – Safety Instructions; Attention: Read carefully before attempting to; Valve and Solenoid Position; Wiring; WARNING; Installation and Service Instructions; For
- Page 18 – Alco Controls Division • Emerson Electric Co.
- Page 21 – List of Illustrated Parts
- Page 22 – Electric Heat Only
1104 Form # AM-307-02
American Metal Ware
®
Installation, Operation & Service Manual
For
High Speed Brewing Urn (Top Line)
Model 87710
Dual Wall Insulated
Electric
Steam
Special Features
After completing installation and set-up, the
equipment owner should keep this manual for
future reference.
© Grindmaster Corporation™, 1995
PRINTED IN USA
Grindmaster Corporation™
4003 Collins Lane
Louisville, Kentucky 40245 USA
(502) 425-4776
(800) 695-4500
(USA and Canada only)
(800) 568-5715
(technical service only)
FAX: (502) 425-4664
www.grindmaster.com
X
TABLE OF CONTENTS
General Description.................................3
Roughing-In Drawing...............................4
Installation...............................................5
Spray-Over Time/Volume/Rate................6
How To Brew............................................7
Thermostat/Adjustments/Timer...............8
Care and Cleaning..................................9
Explanation of Agitation System............10
Operation Malfunction and Service........11
Dual Lever Control................................12
Troubleshooting Level Control...............14
Service/Troubleshooting Agitation.........18
Installation/Service for Solenoid Valve...18
Sprayover Pump Breakdown.................20
Illustrated Parts Breakdown...................21
List of Illustrated Parts...........................22
Parts List...............................................23
Wiring Diagram - Controls.....................24
Heater Wiring Diagram - 208V/240V......25
Heater Wiring Diagram - 480V..............26
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
American Metal Ware 87710E Coffee Urn Page 3 General Description This urn is an automatic, push button operated, volume brewing unit. It consists of a non- pressure vented water compartment of large capacity into which two stainless steel coffee liners are inserted. Also installed within this water ...
Installation 1. 2. 3. 4. IMPORTANT TO ALLOW 6” CLEAR SPACE FOR ACCESS TO CONTROL BOX. Urn should be level, both front to back and left to right. CONNECT WATER LINE. 3/8” NPT water inlet located at left end and provide shutoffvalve and union in supply line near urn. 140 O F. hot water must be used, 3...
Page 6 American Metal Ware 87710E Coffee Urn Spray-Over Time - Volume - Rate Timer and spray-over rate are factory set as per information below. If other volumes ofwater or a faster or slower spray-over rate is desired, see following instructions: Timer Adjustment Turn adjustment knob clockwise to d...
