Page 2 - PRODUCT SPECIFICATIONS; TABLE OF CONTENTS
2 Introduction .......................................................................................................................... 3 Impor tant Safet y Instructions. ........................................................................................... 3 - 4 Specif ic Safet y Rules. .......
Page 3 - READ ALL INSTRUCTIONS BEFORE USING THIS PRODUCT; Stay alert and exercise control.; GROUND FAULT CIRCUIT INTERRUPTER PROTECTION; IMPORTANT SAFETY INSTRUCTIONS
3 W A R N I N G Read and understand all instructions . Failure to follow all instructions listed below may result . W A R N I N G When using this product basic precautions should always be followed, including the following READ ALL INSTRUCTIONS BEFORE USING THIS PRODUCT To reduce the risk of injur...
Page 4 - SAVE THESE INSTRUCTIONS; EXTENSION CORDS; W A R N I N G
4 IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS EXTENSION CORDS by a marking “Acceptable for use with outdoor appliances; store indoors while not in use.” Use only extension cords having an electrical rating not less than the rating of the product. Do not use damaged extension cords. Examine...
Page 6 - 'RQRWXVHDFLGVDONDOLQHVVROYHQWVÀDPPDEOHPDWHULDOEOHDFKHV
63(&,),&6$)(7<58/(6 SOXJ,IWKHSOXJVWLOOGRHVQRW¿WFRQWDFWDTXDOL¿HGHOHFWULFLDQWRLQVWDOOWKHSURSHUZDOORXWOHW Do not change the equipment plug, extension cord receptacle, or extension cord plug in any way. ake sure your extension cord is in good condition. When using an extension cord, be sure...
Page 7 - SYMBOLS
S BOL NA E DESIGNATION E PLANATION V Volts Voltage A Amperes Current +] +HUW] )UHTXHQF\F\FOHVSHUVHFRQG W Watt Power no No Load Speed Rotational speed, at no load Alternating Current Type of current .../min Per Minute Revolutions, strokes, surface speed, orbits etc., per minute Class II Construction ...
Page 8 - SERVICE
SYMBOLS Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper inter-pretation of these symbols will allow you to operate the product better and safer. SERVICE 6HUYLFLQJUHTXLUHVH[WUHPHFDUHDQGNQRZOHGJHDQGVKRXOGEHSHUIRUPHGRQO\E\DTXDOL¿HGVHUYLFHWHFK...
Page 9 - Pressure washer power cord; ELECTRICAL; ELECTRICAL CONNECTION; power supply that; DOUBLE INSULATED
Fig. 1 Pressure washer power cord 9 ELECTRICAL NOTE: Servicing of a product with double insulation requires extreme care and knowledge of the system and your nearest authorized service center for repair. Always use original factory replacement parts when servic-ing. ELECTRICAL CONNECTION This produc...
Page 10 - GROUND FAULT CIRCUIT INTERRUPTER
10 ELECTRICAL **Ampere rating (on product data plate) 0-2.0 2.1-3.4 3.5-5.0 5.1-7.0 7.1-12.0 12.1-16.0 Cord Length Wire Size (A.W.G.) 25' 16 16 16 16 14 14 50' 16 16 16 14 14 12 100' 16 16 14 12 10 --- W A R N I N G Keep the extension cord clear of the working area. Position the cord so that it will...
Page 11 - KNOW YOUR PRESSURE WASHER; DETERGENT TANK; TRIGGER HANDLE
11 KNOW YOUR PRESSURE WASHER The safe use of this product requires an understanding of the information on the tool and in this operator’s manual as well as a knowledge of the project you are attempting. Before use of this product, familiarize yourself with all operating features and safety rules. ( ...
Page 12 - ASSEMBLY; UNPACKING
12 ASSEMBLY W A R N I N G Do not use this product if any parts on the Packing List are already assembled to your productwhen you unpack it. Parts on this list are not assembled to the product by the manufacturer andrequire customer installation. Use of a product that may have been improperly assembl...
Page 13 - CONECTING THE WATER SUPPLY TO THE PRESSURE WASHER; Before connecting the garden hose to the pressure washer:; To connect the garden hose to the machine:
13 ASSEMBLY CONECTING THE WATER SUPPLY TO THE PRESSURE WASHER (See Figure 3.) C A U T I O N : Always observe all local regulations when connnecting hoses to the water main. Some areashave restrictions against connecting directly to public drinking water supply to prevent thefeedback of chemicals int...
Page 14 - USING THE TELESCOPING HANDLE; ASSEMBLING WAND TO PRESSURE WASHER GUN
14 ASSEMBLY USING THE TELESCOPING HANDLE (See Figure 4.) To use the telescopic handle, pull up on it until the pins click into position. To store the handle, push the spring pins in, and press down on the handle. CONNECTING HIGH PRESSURE HOSE TO TRIGGER HANDLE (See Figure 6.) Connect the high ...
Page 15 - SOAP BOTTLE; INSTALLING GUN HOLDER AND CORD RETENTION CLIPS
15 ASSEMBLY SOAP BOTTLE (See Figure 7.) free connection. Fill bottle with approved pressure washer detergents / soaps only. INSTALLING GUN HOLDER AND CORD RETENTION CLIPS ( See Figure 8.) To Install --Push front To Remove--Firmly pull up Fig. 8 Slide round gun holder onto bracket Slide ...
Page 16 - CONNECTING THE GARDEN HOSE
16 ASSEMBLY Fig. 9 CONNECTING THE GARDEN HOSE (See Figure 9.) C A U T I O N : Always observe all local regulations when connecting hoses to the water main. Some areas have restrictions against connecting directly to public drinking water supply to prevent the feedback of preventer is usually permitt...
Page 17 - OPERATION; APPLICATIONS; Using spray wand; ADDING DETERGENT TO THE PRESSURE WASHER
OPERATION W A R N I N G Do not allow familiarity with the product to make you careless.Remember that a careless fraction of DVHFRQGLVVXI¿FLHQWWRLQÀLFWVHULRXVLQMXU\ W A R N I N G $OZD\V ZHDU H\H SURWHFWLRQ ZLWK VLGH VKLHOGV PDUNHG WR FRPSO\ ZLWK$16, = )DLOXUH WR GR VRFRXOGUHVXOWLQREMHFWVEHLQJWKURZQLQ...
Page 18 - STARTING AND STOPPING THE PRESSURE WASHER
18 OPERATION STARTING AND STOPPING THE PRESSURE WASHER (See Figure 11.) C A U T I O N : Do not run the pump without the water supply connected and turned on. Connect the garden hose. Turn the garden hose on then squeeze the high pressure trigger to relieve air pressure. Once a steady stream of w...
Page 19 - USING THE SPRAY WAND TRIGGER; USING NOZZLE; Trigger; Spray wand
19 OPERATION USING THE SPRAY WAND TRIGGER (See Figure 12.) For greater control and safety, keep both hands on the trigger handle at all times. Pull back and hold the trigger to operate the pressure washer. - W A R N I N G Do not slide lock-out button when you have the trigger at back position. U...
Page 20 - MOVING THE PRESSURE WASHER; To move the pressure washer; OPERATING THE PRESSURE WASHER; SOAP APPLICATION
20 OPERATION To clean: Install the detergent bottle on the spray wand. Start the pressure washer and spray the detergent on a dry surface using long, even, overlapping strokes. To prevent streaking, do not allow detergent to dry on the surface. To rinse: Using the desired tip, spray away f rom...
Page 21 - MAINTENANCE; GENERAL MAINTENANCE; NOZZLE MAINTENANCE
21 MAINTENANCE W A R N I N G When servicing, use only identical replacement parts.Use of any other parts may create a hazard or cause product damage.. W A R N I N G Always wear eye protection marked to comply with ANSI Z87.1. Failure to do so could result inobjects being thrown into your eyes, resul...
Page 22 - STORING THE PRESSURE WASHER; QUICK WINTERIZING PROCEDURE
22 MAINTENANCE Unplug the pressure washer. Turn off the pressure washer and shut off the water supply. Pull trigger to release water pressure. Remove the nozzle from the spray wand. NOTE: Never point the spray wand at your face Using the nozzle cleaning tool provided, free any foreign material...
Page 23 - TAKING A BREAK; WALL MOUNTING INSTALLATION; Telescopic handle use:; I M P O R T A N T
23 MAINTENANCE Fig. 17 Fig. 16 TAKING A BREAK Engage gun safety lock. Turn unit to “OFF” (O) position. Unplug the power cord from the outlet. C A U T I O N : The use of a pump protector is recommended to prevent cold weather damage during storageover the winter months. WALL MOUNTING INSTALLATI...
Page 24 - TROUBLESHOOTING; PROBLEM; POSSIBLE CAUSE
24 TROUBLESHOOTING PROBLEM Motor will not start. Unit does not reachhigh pressure. Output pressure varies high and low. POSSIBLE CAUSE On/Off switch is in the“OFF” (O) position. Power cord is not plugged in. Extension cord is too long. Extension cord is not proper gauge.Extension cord is damaged. El...
Page 25 - PROBLE
TROUBLESHOOTING PROBLE Output pressure varies high and low. (contin-ued) Unit does not reachhigh pressure. Pump is noisy Water leaks from pump (up to 10 drops per min-ute is permissible). Oil is dripping Spray wand, extension, or nozzle leaks. Garden hose connection leaks. POSSIBLE CAUSE Discharge n...
Page 27 - ITEMS NOT COVERED BY WARRANTY:; WARRANTY
27 GREENWORKS™ hereby warranties this product, to the original purchaser with proof of purchase , for a period of one (1) years against defects in materials, parts or workmanship. GREENWORKS™, at its own discretion will repair or replace any and all parts found to be defective, through normal use, f...
Page 28 - EXPLODED VIEW
Page 29 - PARTS LIST
29 ITEM NO. PA RT NO. DESCRIPTION QTY 1 31105368 Telescopic handle Assy 1 2 32202368 Screw ST4.2*16-F Screw ST4*16-F 8 3 34202365 Rubber pad 2 4 34107368 Big press pl e t a 1 5 34108368 Small press pl e t a 1 6 32201368 2 1 7 34117368 Cord hook 2 8 34128319 Cord clip 1 9 31110670 Power cord assy 1 1...
Page 31 - Printed in China on 100% Recycled Paper
Printed in China on 100% Recycled Paper Rev: 03 (05-10-11) TOLL-FREE HELPLINE: 1-888-90WORKS (888.909.6757)
