Page 2 - SPECIFICATIONS; A ELECTRIC CULTIVATOR; CONTENTS
2 Contents .............................................................................................................................. 2 ...................................................................................................................... 2 Important Safety Instructions ............
Page 3 - IMPORTANT SAFETY INSTRUCTIONS
3 READ AND UNDERSTAND ALL INSTRUCTIONS. personal injury. READ THESE INSTRUCTIONS BEFORE USING THE ELECTRIC CULTIVATOR • Read the operator’s manual carefully. Be thoroughly familiar with the controls and the proper use of the equipment. Know how to stop the unit and disengage the controls quickly. • ...
Page 4 - SAVE THESE INSTRUCTIONS; CHILD SAFETY
4 SAVE THESE INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS • switch is off when plugging in. • Never pick up or carry the cultivator while the tines are turning or the motor is running. • Keep cultivator in good working condition. Check all nuts, bolts, and screws at frequent intervals for proper tight...
Page 5 - SPECIFIC SAFETY RULES
5 SAVE THESE INSTRUCTIONS SPECIFIC SAFETY RULES • Do not use near underground electric cables, telephone, lines, pipes, or hoses. If in doubt, contact your utility or telephone company to locate underground services. • If the unit strikes a foreign object, stop the motor, disconnect the extension co...
Page 7 - SYMBOLS; SYMBOL NAME
7 SYMBOLS SYMBOL NAME DESIGNATION/EXPLANATION V Volts Voltage A Amperes Current Hz Hertz Frequency (cycles per second) W Watt Power min Minutes Time Alternating Current Type of current Direct Current Type or a characteristic of current Class II Construction Double-insulated construction Wet Conditio...
Page 8 - SERVICE
8 The following signal words and meanings are intended to explain the levels of risk associated with this product. SERVICE Servicing requires extreme care and knowledge and should be performed only by a qualified service technician. For service we suggest you return the product to your nearest AUTHO...
Page 9 - ELECTRICAL; W A R N I N G; GUIDELINES FOR USING EXTENSION CORDS; Amp Rating
9 ELECTRICAL W A R N I N G KEEP THE EXTENSION CORD CLEAR OF THE TINES AND WORKING AREA. POSITION THE CORD SO THAT IT WILL NOT GET CAUGHT ON LUMBER, TOOLS OR OTHER OBSTRUCTIONS WHILE YOU ARE WORKING WITH A CULTIVATOR. FAILURE TO DO SO CAN RESULT IN SERIOUS PERSONAL INJURY. W A R N I N G THIS CULTIVAT...
Page 10 - ELECTRICAL CONNECTION; Replacement Parts —
10 ELECTRICAL W A R N I N G CHECK EXTENSION CORDS BEFORE EACH USE. IF DAMAGED REPLACE IMMEDIATELY. NEVER USE TOOL WITH A DAMAGED CORD SINCE TOUCHING THE DAMAGED AREA COULD CAUSE ELECTRICAL SHOCK RESULTING IN SERIOUS INJURY. ELECTRICAL CONNECTION This tool is powered by a precision built electric mot...
Page 11 - KNOW YOUR CULTIVATOR
11 KNOW YOUR CULTIVATOR Read this operator’s manual and safety rules before operating your cultivator. Compare the illutration in Fig.2.1 to your cultivator in order to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference. Fig. 2 SAFETY LO...
Page 12 - UNPACKING; PACKING LIST; ASSEMBLY
12 UNPACKING This product requires assembly. • Carefully remove the product and any accessories from the box. Make sure that all items listed in the packing list are included. • Inspect the tool carefully to verify no breakage or damage occurred during shipping. • Do not discard the packing material...
Page 13 - ASSEMBLING THE HANDLEBAR
13 ASSEMBLY ASSEMBLING THE HANDLEBAR (See Figure. 4) • Align the holes on the upper handle with the holes on the lower handle. Insert the bolts, and tighten them using the wing nuts provided. • Fold the handle base on the Fig.3 - 3.1 Step1: Release the wing nuts Step2: Rotate the middle handle base ...
Page 14 - ASSEMBLING THE WHEELS
14 ASSEMBLY ASSEMBLING THE WHEELS (See Figure. 5) The wheels are used to control the depth of operation. To adjust the height of the wheels. 1. Disconnect from power source. 2. Place cultivator in a stable position in Fig. 5 3. Insert the wheel assembly (2) into the support rod (3). (Fig. 5) 4. Alig...
Page 15 - INSTALLING THE TINES
15 ASSEMBLY INSTALLING THE TINES (See Figure 6) The cultivator comes with four tines—For correct operation of the unit, the tines must be installedin the correct order. The cultivator may be used with four tines or two tines. • Disconnect from power source. • Lean the unit back on its wheels so that...
Page 16 - TINES INSTALLED CORRECTLY
16 ASSEMBLY TINES INSTALLED CORRECTLY (See Figure. 7) NOTE: tine blades should point towards the ground (Fig. 7). NOTE: The tiller will not operate properly if the tines are not installed correctly. If there is a problem with the cultivating operation of the tiller, check the tines for proper positi...
Page 17 - OPERATION; STARTING THE CULTIVATOR; STOPPING THE TILLER/CULTIVATOR
17 OPERATION W A R N I N G Do not allow familiarity with tools to make you care-less. Remember that a careless fraction of a W A R N I N G Always wear safety goggles or safety glasses with side shields when operating tools. Failure to do so could result in objects being thrown into your eyes, result...
Page 18 - PREPARING THE SEED BED
1 8 OPERATION PREPARING THE SEED BED The cultivator can be used to break up garden soil and prepare a seedbed for planting. Plan ahead to leave enough room between the seed rows to allow for machine cultivating after the plants have grown. TILLING SOD: Tilling sod into the soil is not recommended. I...
Page 19 - MAINTENANCE; GENERAL MAINTENANCE; STORING THE CULTIVATOR; PREPARING FOR USE AFTER STORAGE
19 MAINTENANCE W A R N I N G WHEN SERVICING, USE ONLY IDENTICAL REPLACEMENT PARTS. USE OF ANY OTHER PARTS MAY CREATE A HAZARD OR CAUSE PRODUCT DAMAGE. W A R N I N G ALWAYS WEAR SAFETY GOGGLES OR SAFETY GLASSES WITH SIDE SHIELDS DURING PRODUCT OPERATION. IF OPERATION IS DUSTY, ALSO WEAR A DUST MASK. ...
Page 20 - TROUBLESHOOTING; PROBLEM; REMEDY
20 TROUBLESHOOTING PROBLEM Motor fails to start when switch trigger is depressed. Motor runs but tines do not move. CAUSE Power cord is not plugged in or connection is loose. Household circuit breaker is Cultivator circuit overload protection is tripped. Let unit rest for 4 minutes, then repeat step...
Page 21 - LIMITED FOUR-YEAR WARRANTY; proof of; ITEMS NOT COVERED BY WARRANTY:; TRANSPORTATION CHARGES:
21 LIMITED FOUR-YEAR WARRANTY GREENWORKS™ hereby warranties this product, to the original purchaser with proof of purchase , for a period of four (4) years against defects in materials, parts or workmanship. GREENWORKS™, at its own discretion will repair or replace any and all parts found to be defe...
Page 22 - PARTS
Page 24 - PARTS LIST
24 PARTS LIST ITEM # PART NO. QTY DESCRIPTION 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 33203289 31105289 32208250 33323250-1 3220439 32204283 3410835-8 34114288 34111288 3220537 33303289 34106488 36290135 3220898 31101...
Page 26 - Printed in China on 100% Recycled Paper
Printed in China on 100% Recycled Paper Rev: 0 2 ( 04 -1 0 -1 3 ) TOLL-FREE HELPLINE: 1-888-90WORKS (888.909.6757)
