Greenheck 464603 - Manual
Greenheck 464603 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Installation Instructions; Insulating the Duct; Vertical Airflow- Horizontal Damper mount
- Page 3 – connection and Operation of temperature; Size limitations
- Page 4 – damper trouble Shooting
Installation, Operation and Maintenance Instructions
Safety WaRNING:
Improper installation, adjustment, alteration,
service or maintenance can cause property damage,
injury or death. Read the installation, operating,
and maintenance instructions thoroughly before
installing or servicing this equipment.
This manual is the property of the owner, and is required
for future maintenance. Please leave it with the owner
when the job is complete.
WaRRaNty
Greenheck warrants this equipment to be free from
defects in material and workmanship for a period of one
year from the purchase date. Any units or parts which
prove to be defective during the warranty period will
be repaired or replaced at our option. Greenheck shall
not be liable for damages resulting from misapplication
or misuse of its products. Greenheck will not be
responsible for any installation or removal costs.
Greenheck will not be responsible for any service work
or backcharges without prior written authorization.
ReceIvING aNd HaNdlING
Upon receiving dampers, check for both obvious and
hidden damage. If damage is found, record all necessary
information on the bill of lading and file a claim with
the final carrier. Check to be sure that all parts of the
shipment, including accessories, are accounted for.
Dampers must be kept dry and clean. Indoor storage
and protection from dirt, dust and the weather is highly
recommended. Do not store at temperatures in excess of
100°F.
International Maritime fire test Procedure
code
USCG Type Approved
Approval Number 164.139/0007/0
Part number 464603
IMO-XXX & SSIMO-XXX series
fire and combination fire Smoke dampers
vertical or Horizontal Mount
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
IF HEIGHT <=11.00 in. (279mm) IF HEIGHT >11.00 (279mm) 6 in. (152mm) 18 in. (457mm) 6 in. (152mm) 18 in. (457mm) 6 in. (152mm) 6 in. (152mm) 18 in. (457mm) 18 in. (457mm) Installation Instructions Greenheck’s IMO dampers were tested per the International Maritime Organization’s Fire Test Proce...
connection and Operation of temperature Response devices (RRl standard, OcI option, and PRv option) RRl - Dampers will be supplied with a thermostat-type temperature response device, as a standard. The device is a RRL (resettable link device), which only incorporates one thermostat and therefore the...
Symptom Possible cause corrective action Frame is ‘racked’ causing blades to Adjust frame such that it is square bind on jamb seals and plumb Actuator linkage loose Close damper, disconnect power, adjust and tighten linkage Defective motor Replace Screws in damper linkage Locate screws and remove Ac...
