Graco Series C - Manual
Graco Series C – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Warnings and Cautions
- Page 4 – Operation
- Page 5 – Storage
- Page 6 – Notes
- Page 7 – Parts List
- Page 10 – Graco Standard Warranty
309445
Rev. E
To find your local Graco authorized service
center:
Call us at 1–800–690–2894
Visit our website at www.graco.com
INSTRUCTIONS–PARTS LIST
Important Safety Instructions
Read all warnings and instructions
in this manual. Save these
instructions.
Pressure Roller with 20”
Heavy Duty Extension, EvenFlow
t
Roller
Frame and Contractor
t
Inline Valve
– For the rolled application of architectural paints and
coatings –
Model 245397, Series C
20 in. (50 cm) Heavy-Duty Extension
9 in. (23 cm) EvenFlow
Roller Frame
1/2 in. (13 mm) Nap Roller Cover
Contractor
Inline Valve
3600 psi (24.8 MPa, 248 bar) Maximum Fluid Inlet Pressure
*
The best operating pressure is the lowest pressure that provides
an even paint supply to the roller and typically does not exceed
300 psi (2.1 MPa, 21 bar).
*
CAUTION
Never leave water in the pump, inline valve, or roller frame.
Doing so could cause corrosion and damage from freezing.
For storage, flush the system with Graco Pump Armor
or
mineral spirits/paint thinner.
GRACO INC.ąP.O. BOX 1441ąMINNEAPOLIS, MNą55440-1441
COPYRIGHT 2001, GRACO INC.
Graco Inc. is registered to I.S. EN ISO 9001
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 309445 Warnings and Cautions EQUIPMENT MISUSE HAZARDMisuse can cause the equipment to rupture ormalfunction and result in serious injury.To help prevent injury Do not modify the extension tube or rollerframe or use parts not designed for thisequipment. Do not use 1,1,1–trichloroethane, methylenech...
4 309445 Operation SKIN INJECTION HAZARDTo reduce the risk of a fluid injectioninjury, do not operate the inline valve withthe tip guard or trigger guard removed. WARNING In-Line Valve Trigger Safety Lever For SAFETY ON position, rotate trigger safety lever soit is in line with trigger. For SAFETY O...
309445 5 5. Prime pump with water or flushing fluid for oil–based materials. Use the lowest pump primingpressure setting. 6. Turn prime/spray valve to SPRAY. NOTE: Perform Step 7 at the lowest pressure pos-sible. 7. Trigger inline valve until flushing fluid begins todilute the paint. 8. Place roller...
