Graco Model 244512 Series C - Manual
Graco Model 244512 Series C – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Warnings; Additional Roller Covers; WARNING
- Page 3 – Installation; Cleaning
- Page 4 – Storage
332981A
EN
Kit Instructions
Pressure Roller
Model 244512, Series C / Model 16W441, Series A
3600 psi (24.8 MPa, 248 bar) Maximum Fluid Inlet Pressure*
•
20 in. (50 cm) heavy-duty extension
•
45° swivel adapter
•
9 in. (23 cm) roller frame
•
1/2 in. (13 mm) nap roller cover
*Use the lowest pressure that provides an even paint supply to
the roller; typically less than 300 psi (2.1 MPa, 21 bar)
Important Safety Instructions
Read all warnings and instructions in this man-
ual. Save these instructions.
NOTICE
Never leave water in the pump, gun, or pressure roller.
Doing so could cause corrosion and damage from
freezing. For storage, flush the system with Graco
Pump Armor
™
or mineral spirits/paint thinner.
To find your local Graco/Magnum
authorized service center:
•
1-888-541-9788
•
Magnum.Graco.com
•
Graco/Magnum Authorized
Service Centers list 302367
ti22333a
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 332981A Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama-tion point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manual or on w...
Operation 332981A 3 Installation Assemble the pressure roller as shown in the Parts Drawing on page 4. Attach pressure roller assembly to spray gun. Pressure Relief Procedure 1. Engage gun trigger lock. 2. Shut off power to pump. 3. Turn prime/spray valve to the PRIME position to relieve pressure in...
Storage 4 332981A Storage If you are going to store the airless equipment for an extended period of time after flushing with water-base fluid, flush again with Graco Pump Armor or mineral spirits/paint thinner. Leave the fluid in the system during storage. Parts Parts List 1 14 5 4 19 27 2 23 23 12 ...
