Graco 954088 - Manual - manualsarea.com

Page 2 - Warning Symbol; Caution Symbol; CAUTION; WARNING; EQUIPMENT MISUSE HAZARD

2 309489 Table of Contents Warnings 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Installation 5 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Operation 8 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Maintenance...

Page 3 - INJECTION HAZARD; MOVING PARTS HAZARD

3 309489 WARNING INJECTION HAZARD Spray from the gun, leaks or ruptured components can inject fluid into your body and cause extremely serious injury, including the need for amputation. Fluid splashed in the eyes or on the skin can also cause serious injury. D Fluid injected into the skin is a serio...

Page 4 - FIRE AND EXPLOSION HAZARD; TOXIC FLUID HAZARD

4 309489 WARNING FIRE AND EXPLOSION HAZARD Improper grounding, poor ventilation, open flames or sparks can cause a hazardous condition and re- sult in a fire or explosion and serious injury. D Ground the equipment and the object being sprayed. Refer to Grounding on page 5. D If there is any static s...

Page 5 - Installation; General Information

5 309489 Installation General Information NOTE: Reference numbers and letters in parentheses refer to callouts in the Figs. and parts drawing. NOTE: Always use Genuine Graco Parts and Acces- sories, available from your Graco distributor. Grounding WARNING FIRE AND EXPLOSION HAZARD Before operating t...

Page 6 - Pail and Drum Length Pumps; Evenflo

6 309489 Installation NOTE: Reference numbers and letters in parentheses in the text refer to callouts in the figure illustrations and the parts drawing.The Typical installation shown on page 7 is only a guide to electing and installing required and optional accessories. For assistance in designing ...

Page 7 - Typical Installation

7 309489 Installation Typical Installation ti3003a7 KEY A B C D E H J K L M 38 52 1/2” Minimum A L C 38 E D J B H K 52 M Evenflo R Air Regulator Bleed-Type Master Air Valve Pump Runaway Valve Air Line Filter Air Line Lubricator Pump Air Regulator Drain Valve (part of 38, Evenflo r Valve) Pump Ground...

Page 8 - Operation; Startup

8 309489 Operation Pressure Relief Procedure With the Evenflo r control, its bypass valve, and the pump Relax-A-Valve properly set, fluid pressure is relieved from the pump and hose each time you re- lease the gun trigger. Always engage the gun trigger safety when you stop spraying. To relieve air p...

Page 9 - Shutdown and Care of the Pump

9 309489 Operation Use the air regulator (A) to control fluid pressure and pump speed. Always use the lowest pressure neces- sary to get the desired results. Higher pressures cause premature pump wear and spray tip wear, and usually do not improve the spray pattern. WARNING To reduce the risk of ove...

Page 10 - Maintenance; Lubrication; Flushing; Corrosion Protection

10 309489 Maintenance Lubrication If your system includes an automatic air line lubricator, adjust the lubricator as instructed in the separate instruction manual. For manual lubrication, each day, remove the air inlet hose and place 12 to 15 drops of high quality, light motor oil in the inlet. Reat...

Page 11 - Troubleshooting

11 309489 Troubleshooting WARNING To reduce the risk of serious injury whenever you are instructed to relieve pressure, always follow the Pressure Relief Procedure on page 8. Relieve the pressure before you check or service any system equipment. NOTE: Check all possible problems and solutions before...

Page 12 - Service; Displacement Pump Repair; Piston

12 309489 Service Displacement Pump Repair Before you start: 1. A packing repair kit, part no. 946761 is available. This kit includes two glands and eight packings for the motor as well as o-rings, packings, and wash- ers for the displacement pump. For the best re- sults use all the parts in the kit...

Page 14 - Parts

14 309489 Parts 43 30 31 32 34 35 33 50 2 3* 45 1 44 4 6 *8 7 *8 39 9 28 37 5 10* 12 14 15 1617 20 18* 1922* 18* 2021 *11 13 25 *23 26 27 24 52 53 46 48 47 51 42 29 36 49 38

Page 17 - Dimensions; Bottom View

17 309489 Dimensions 1” (25.4 mm) 1-- 1/4” (31.8 mm) 14-- 1/2” (368.3 mm) 6-- 3/4” (171.4 mm) 3/8 npt 11/16” (17.5 mm) OD 45 _ 45 _ 6-- 1/2” (165.1 mm) 2-- 3/32” (53.2 mm) Four 1/4”-- 20 Holes on a 4-- 1/4” (108 mm) Dia. Bolt Circle Bottom View

Page 19 - Notes

Page 20 - Graco Standard Warranty; Graco Information

20 309489 Graco Standard Warranty Graco warrants all equipment manufactured by Graco and bearing its name to be free from defects in material and workmanship on the date of sale to the original purchaser for use. With the exception of any special, extended, or limited warranty published by Graco, Gr...

Graco 954088 - Manual

Table of Contents:

Summary

Other Graco Models