Graco 3A0101C - Manual

Operation 6 3A0101C Drum Installation/Replacement Installation NOTE: Carbide Flail Cutter drums do not require specific orientation or direction. Carbide Millers and Diamond Blades are directional. They should be stacked so that the arrows on the Millers and Blades face the same direction as the rot...

Operation 3A0101C 7 Starting the Engine 3. Engage Rear Wheel Brake (G) to prevent Grin- dLazer from moving. 4. 480/630 Models Only: Attach LineDriver to GrindLazer. 5. Push down on handle bars until drum is locked into UP position. 6. 480/630 Models Only: Make sure Engine Stop Switch (C) is in UP po...

Operation 8 3A0101C Cutting Material 1. Start Engine , see page 7. 2. Connect Emergency Shut-Off Cord (C) to operator. 3. Disengage Rear Wheel Brake (G). 4. Slide Engine Throttle Lever (A) to desired setting. NOTE: Drum clutch will not engage when engine is running at idle. 480/630 Models: LineDrive...

Operation 3A0101C 9 Depth Control Wheels Using Depth Control Wheels as a 5 in. or 10 in. Wide Cutting Guide To make a 5 in. cut , install two spacers (S) on outside of Depth Control Wheels (K). To make a 10 in. cut , install two spacers (S) on inside of Depth Control Wheels (K). How to Level the Dru...

Operation 10 3A0101C Stop Cutting Material 1. Push down on handle bars until drum is locked into UP position. 2. Slide Engine Throttle Lever (A) to low setting. 3. Turn Engine Power Switch (B) OFF. Clean Up Clean the entire exterior of the machine after it has cooled at the end of each work day. Che...

Cutting Drum Assemblies 3A0101C 11 Cutting Drum Assemblies Different drum configurations can be used for different applications. There are three different types of drum assemblies compatible with the GrindLazer: carbide flails, carbide millers, and diamond blades. Carbide Flail Cutter/Assembly Gradu...

Maintenance 12 3A0101C Maintenance The following steps should be performed to maintain proper operation and sustain the life of the GrindLazer. BEFORE OPERATION: • Visually inspect the entire unit for damage or loose connections • Check engine oil (see engine manual) • Check drum bushings and cutter...

Technical Data 3A0101C 13 Technical Data GrindLazer 270 (Model 571002) Dimensions Unpackaged Packaged Height in./cm: 46 (116.8) 50.5 (128.3) Width in./cm: 28 (71.1) 37 (94.0) Length in.cm: 62 (157.5) 73 (185.4) Weight lb/kg: 300 (136) 400 (181) Noise (dBa) Sound Power per ISO 3744: 107.3 Sound Press...

All written and visual data contained in this document reflects the latest product information available at the time of publication. Graco reserves the right to make changes at any time without notice. Original instructions. This manual contains English. MM 3A0101 Graco Headquarters: Minneapolis Int...