Graco 309911C - Manual
Graco 309911C – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Tools Required
- Page 3 – Disassembly
- Page 5 – Installation
- Page 8 – Maintenance; Changing the TSL
- Page 9 – Parts
- Page 10 – Graco Standard Warranty; Graco Information
309911C
EN
Instructions
Pump Wet-cup Flush
Kits
COMPLETE KITS CONVERT ELECTRIC REACTOR
™
TO WET-CUP FLUSH
DESIGN
Kits include reservoir, pump wet-cup, tubes, and fittings
Part No. 248061, for Reactor Models E-20 and E-XP1
Part No. 248062, for Reactor Model E-XP2
Part No. 248063, for Reactor Model E-30
RESERVOIR KIT MODIFIES ELECTRIC REACTOR TO USE WET-CUP FLUSH
DESIGN
Kit includes reservoir, tubes, and fittings (pump not included)
Part No. 246928
TI3765a-2
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Flush Pump Before Installing Kit 2 309911C Flush Pump Before Installing Kit See F IG . 1. Flush component A (ISO) side from pump A inlet (C) to PRESSURE RELIEF/SPRAY valve (SA) on Reactor fluid manifold. See Reactor operation manual for details. Tools Required • 12 in. adjustable wrench • 1/4 in. op...
Disassembly 309911C 3 Disassembly Numbers and letters in parentheses refer to the fig-ures and the parts list and drawing on page 9. 1. If pumps are not parked, press . Trigger gun until pumps stop. After fluid pressure drops below 700 psi (4.9 MPa, 49 bar), motor will run until pumps are at bottom ...
Installation 309911C 5 Installation 1. Place pump in vise with soft jaws. Remove brass packing nut assembly. 2. Install new wet-cup assembly (10). Screw it all the way down, so external o-ring (R) seats on top of pump housing. Wrap base of wet-cup with a rag and tighten securely with channel locks. ...
