Graco 309511 - Manual
Graco 309511 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Warnings and Cautions; WARNING
- Page 3 – Pressure Relief Procedure
- Page 4 – Operation
- Page 5 – Rolling Techniques
- Page 6 – Cleaning; Storage
- Page 7 – Roller Parts; Parts List; Additional Roller Covers
- Page 8 – Limited Warranty
309511
Rev. D
Operating Instructions
INSTRUCTIONS
This manual contains important
warnings and information.
READ AND KEEP FOR REFERENCE.
Pressure Roller Attachment
Model 245907, Series C
D
9 in. (23 cm) roller frame with 45
_
angle and 12 in. reach
D
1/2 in. (13 mm) nap roller cover
3600 psi (24.8 MPa, 248 bar) Maximum Fluid Inlet Pressure
*
The best operating pressure is the lowest pressure that provides
an even paint supply to the roller and typically does not exceed
300 psi (2.1 MPa, 21 bar).
*
CAUTION
Never leave water in the pump, gun, or pressure roller.
Doing so could cause corrosion and damage from freezing.
For storage, flush the system with Graco Pump Armor
t
or
mineral spirits/paint thinner.
GRACO INC.
P.O. BOX 1441
MINNEAPOLIS, MN
55440–1441
E
COPYRIGHT 2002, GRACO INC.
Graco Inc. is registered to I.S. EN ISO 9001
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 309511 Warnings and Cautions EQUIPMENT MISUSE HAZARDMisuse can cause the equipment to rupture or malfunction and result in serious injury. To help prevent injury D Do not modify the extension tube or roller frame or use parts not designed for thisequipment. D Do not use 1,1,1–trichloroethane, meth...
309511 3 Pressure Relief Procedure WARNING To help prevent injection injuries,follow this procedure wheneveryou stop painting. psi/MPa/bar 1 . Engage gun trigger safety latch. 2 . Shut off power to pump. 3 . Turn prime/spray valve to the PRIME to relievepressure in system. 4 . Remove gun trigger saf...
4 309511 Operation 1 . Follow pump priming instructions prior toassembling roller. 2 . Do not put tip and guard on spray gun. 3 . Turn prime/spray valve to SPRAY. 4 . Turn pressure control to lowest setting or rollersymbol. Fig. 1. Fig. 1 5 . Remove gun trigger safety latch. Trigger the gunonce unti...
