Graco 309032L- User Manual
Graco 309032L– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Warnings; WARNING
- Page 3 – Operation; Pressure Relief Procedure; Adjustment
- Page 4 – Service; Disassembly; Troubleshooting
- Page 5 – Parts
- Page 6 – Graco Standard Warranty; Graco Information
Instructions
Pro-Shot
™
Grease
Dispense Valve
309032L
EN
For high pressure grease dispense. For professional use only.
Model No. 242055, Series B, 1/4 npt Fluid Inlet
Model No. 242056, Series B, 1/4 npt Fluid Inlet with Coupler
Model No. 242057, Series B, 3/8 npt Fluid Inlet
Model No. 242058, Series B, 3/8 npt Fluid Inlet with Coupler
Model No. 24H399, Series A, 1/4-19 bspt Fluid Inlet
Model No. 24H400, Series A, 1/4-19 bspt Fluid Inlet with Coupler
Model No. 24H401, Series A, 3/8-19 bspt Fluid Inlet
Model No. 24H402, Series A, 3/8-19 bspt Fluid Inlet with Couple
Model No. 24H403, Series A, 1/4-19 bspp Fluid Inlet
Model No. 24H404, Series A, 1/4-19 bspp Fluid Inlet with Coupler
Model No. 24H405, Series A, 3/8-19 bspp Fluid Inlet
Model No. 24H406, Series A, 3/8-19 bspp Fluid Inlet with Coupler
8000 psi (55.2 MPa, 552 bar) Maximum Working
Pressure
Important Safety Instructions
Read all warnings and instructions in this
manual. Save these instructions.
.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Warnings 2 309032L Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama-tion point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manua...
Operation 309032L 3 Operation Pressure Relief Procedure Follow the Pressure Relief Procedure whenever you see this symbol. 1. Close the supply pump’s bleed-type master air valve (required in pneumatic systems). 2. Open the dispensing valve until pressure is fully relieved. 3. Open the fluid drain va...
Service 4 309032L Service Refer to Parts Drawing, page 5, for following instruc-tions. Disassembly 1. Relieve the pressure. See Pressure Relief Proce-dure on page 3. 2. Check all parts thoroughly when disassembling and carefully replace any worn or damaged par ts. 3. Remove bottom seat adapter (10) ...
