Graco 288628 - Manual

Model
288629

ti8508a

Texture Guns

Models: 288628, 288629, and 245924

125 psi (8.75 bar, 0.875 MPa) Maximum Air Working Pressure
70 psi (4.9 bar, 0.49 MPa) Maximum Fluid Working Pressure

- For Water-Based Materials Only -

The following Warnings are for the setup, use, grounding, maintenance and repair of this equipment. The exclamation point
symbol alerts you to a general warning and hazard symbols refer to procedure-specific risks. Refer back to these Warnings.
Additional, product-specific warnings may be found throughout the body of this manual where applicable.

PRESSURIZED EQUIPMENT HAZARD

Fluid from the gun/dispense valve, leaks, or ruptured
components can splash in the eyes or on skin and
cause serious injury.

• Follow

Pressure Relief Procedure

in this manual when

you stop spraying and before cleaning, checking, or
servicing equipment.

• Tighten all fluid connections before operating the

equipment.

• Check hoses, tubes, and couplings daily. Replace worn

or damaged parts immediately.

FIRE AND EXPLOSION HAZARD

Flammable fumes, such as solvent and paint fumes,
in

work area

can ignite or explode. To help prevent

fire and explosion:

• Use equipment only in well ventilated area.
• Eliminate all ignition sources; such as pilot lights, ciga-

rettes, portable electric lamps, and plastic drop cloths
(potential static arc).

• Keep work area free of debris, including solvent, rags

and gasoline.

• Do not plug or unplug power cords, or turn power or light

switches on or off when flammable fumes are present.

• Ground all equipment in the work area. See

Grounding

instructions.

• Use only grounded hoses.
• Hold gun firmly to side of grounded pail when triggering

into pail.

• If there is static sparking or you feel a shock,

stop oper-

ation immediately.

Do not use equipment until you

identify and correct the problem.

• Keep a working fire extinguisher in the work area.

EQUIPMENT MISUSE HAZARD

Misuse can cause death or serious injury.

• Do not operate the unit when fatigued or under the influ-

ence of drugs or alcohol.

• Do not exceed the maximum working pressure or tem-

perature rating of the lowest rated system component.
See

Technical Data

in all equipment manuals.

• Use fluids that are compatible with equipment wetted

parts. See

Technical Data

in all

equipment manuals.

Read fluid manufacturer’s warnings. For complete infor-
mation about your material, request MSDS forms from
distributor or retailer.

• Check equipment daily. Repair or replace worn or dam-

aged parts immediately with genuine manufacturer’s
replacement parts only.

• Do not alter or modify equipment.
• Use equipment only for its intended purpose. Call your

distributor for information.

• Route hoses and cables away from traffic areas, sharp

edges, moving parts, and hot surfaces.

• Do not kink or over bend hoses or use hoses to pull

equipment.

• Keep children and animals away from work area.
• Comply with all applicable safety regulations.

PERSONAL PROTECTIVE EQUIPMENT

You must wear appropriate protective equipment
when operating, servicing, or in the operating area
of the equipment to help protect you from serious
injury. This equipment includes but is not limited to:

• Protective eyewear
• Clothing and respirator as recommended by the fluid and

solvent manufacturer

• Gloves
• Hearing protection

CALIFORNIA PROPOSITION 65

This product contains a chemical known to the State of
California to cause cancer, birth defects or other
reproductive harm. Wash hands after handling.

WARNINGS

311777F

IMPORTANT SAFETY INSTRUCTIONS.

Refer to your

sprayer instruction manual for Pressure Relief, priming and
spray instructions. Keep these instructions.

Repair

English

ti8808a

Model
245924,
with hopper

Model
288628,
no hopper