Graco 287713 - Manual
Graco 287713 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Warnings; WARNING; EQUIPMENT MISUSE HAZARD; SKIN INJECTION HAZARD; PRESSURIZED EQUIPMENT HAZARD; PERSONAL PROTECTIVE EQUIPMENT
- Page 3 – Trigger Lock; relieve pressure
- Page 4 – Cleaning; Relieve pressure; Storage
- Page 5 – Parts; Description
- Page 6 – ASM; Standard Warranty; TO PLACE AN ORDER OR FOR SERVICE
311082B
Instructions
Important Safety Instructions
Read all warnings and instructions in this manual.
Save these instructions.
Pressure Roller with
20-inch Fixed Extension
- For application of architectural paints and coatings -
Model 287713, Series A
•
20 inch (50 cm) heavy-duty extension
•
9 inch (23 cm) roller frame
•
1/2 inch (13 mm) nap roller cover
3600 psi (24.8 MPa, 248 bar) Maximum Working
Pressure*
*The best operating pressure is the lowest pressure that
provides an even paint supply to the roller and typically
does not exceed 300 psi (2.1 MPa, 21 bar).
CAUTION
Never leave water in pump, gun or pressure roller.
Doing so could cause corrosion and damage from
freezing. For storage, flush the system with Pump
Defender
™
or mineral spirits/paint thinner.
WLD
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Warnings 2 311082B Warnings The following warnings are for the safe setup, use, grounding, maintenance, and repair of this equipment. The excla-mation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. Refer back to these Warnings. Additional, prod...
Pressure Relief Procedure 311082B 3 Pressure Relief Procedure 1. Turn power switch OFF and unplug sprayer power cord. 2. Turn spray/prime valve to PRIME to relieve pressure. 3. Hold metal part of gun firmly to side of a grounded metal pail. Trig-ger gun. 4. Engage trigger lock. If you suspect the sp...
Cleaning 4 311082B Cleaning This is the procedure for flushing/cleaning the pressureroller. The sprayer and gun you are using may have ad-ditional flushing/cleaning instructions; such as cleaningfilters and screens. See sprayer and gun operation man-uals. 1. Relieve pressure , page 3. 2. Remove roll...
