Graco 260104 - Manual
Graco 260104 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Warnings; WARNING
- Page 4 – Installation; Mounting Hose and Nozzle
- Page 5 – Operation; Pressure Relief Procedure
- Page 6 – Troubleshooting
- Page 10 – Technical Data
- Page 11 – Dimensions
- Page 12 – Performance Chart
- Page 13 – Notes
- Page 14 – Graco Standard Warranty; Graco Information
Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441
Copyright 2005, Graco Inc. is registered to I.S. EN ISO 9001
311305E
Instructions - Parts List
APEX
Oil Transfer Pump
For pumping non-flammable fluids, including motor oils, hydraulic
fluid, and antifreeze only. Do not use to pump water.
Model 260100, 5.8 gpm (22.0 lpm), 65 psi (.45 MPa, 4.5 bar) 12 VDC
Model 260101, 4.25 gpm (16.1 lpm), 65 psi (.45 MPa, 4.5 bar) 115 VAC
Model 260102, 8.0 gpm (30.3 lpm), 30 psi (.21 MPa, 2.1 bar) 115 VAC
Model 260104, 4.25 gpm (16.1 lpm), 65 psi (.45 MPa, 4.5 bar) 230 VAC
Important Safety Instructions
Read all warnings and instructions in this
manual. Save these instructions.
EN
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Warnings 2 311305E Warnings The following general warnings are for the setup, use, grounding, maintenance, and repair of this equipment. Additional, more specific warnings may be found throughout the body of this manual where applicable. Symbols appearing in the body of the manual refer to these gen...
Installation 4 311305E Installation The oil transfer pumps are positive displace-ment pumps. The motors are drip proof rated at 3/4 hp. The motors have sealed bearings and require minimal maintenance. All models come with hose, nozzle, 34 in. (864 mm) suc-tion tube assembly, and bung adapter. When u...
Operation 311305E 5 Electrical Installation115 VAC and 230 VAC The 115 VAC models (260101 and 260102) come wired with a short power cord and a grounded electrical plug. Power to the unit must be 115 VAC single phase. If an extension cord is required, it should be a 3-wire cord with a ground. Use a 2...
