Graco 24G980 - Manual
Graco 24G980 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Warnings; WARNING
- Page 4 – Installation; Mount Valve
- Page 5 – Operation; Adjustments; Application Data
- Page 6 – Maintenance; Service; Needle, Seat and Packings
- Page 8 – Air Piston, Spring and Seal
- Page 9 – Replacement Parts and Kits (Double Acting Gun 24G980)
- Page 10 – Replacement Parts and Kits (Single Acting Gun 238377)
- Page 11 – Troubleshooting
- Page 12 – Graco Standard Warranty; Graco Information
308613E
ENG
Instructions
Single Acting and Double Acting Paint Spray Guns for
RoadLazer
™
RoadPak
™
Line Striping System
- For the application of road marking paints and coatings -
- For professional use only -
Model: 238377 (Single-acting gun)
Model: 24G980 (Double-acting gun)
Maximum Working Pressure 3000 psi (21 MPa, 210 bar)
Important Safety Instructions
Read all warnings and instructions in this
manual. Save these instructions.
ti16339a
05952b
238377
24G980
II 2 G
T5
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Warnings 2 308613E Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama-tion point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manua...
Installation 4 308613E Installation Accessories are available from Graco. Be sure all accessories are properly sized to withstand the pres-sures in the system. Mount Valve Mount the valve on a 0.50 in. (12.7 mm) diameter rod on a mounting fixture or a dispensing machine. The paint gun has a clamping...
Operation 308613E 5 Operation Adjustments Set the actuating air to at least 75 psi (5.2 bar) and start the pump. Set the pump speed and pressure to obtain the desired flow rate. Always use the lowest pump speed nec-essary to achieve desired results. Pressure Relief Procedure 1. Shut off the power to...
