Graco 24G979 - Manual
Graco 24G979 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Warnings; WARNING
- Page 3 – Installation; Mount Valve
- Page 4 – Operation; Pressure Relief Procedure
- Page 5 – Nozzle Size Selection
- Page 6 – Maintenance; Oil Dispensing Valve Daily; Service; Needle, Seat and Packings
- Page 7 – Air Piston, Spring and Seals
- Page 8 – Troubleshooting
- Page 9 – Replacement Parts and Kits (Single Acting Gun); Parts List
- Page 10 – Replacement Parts and Kits (Double Acting Gun)
- Page 11 – Valve Seat and O-Ring Kits
- Page 12 – Graco Standard Warranty; Graco Information
Operation
Single Acting and Double Acting Bead Spray Guns for
RoadLazer
™
RoadPak
™
Line Striping System
308612J
EN
- For the application of road marking reflective materials -
- For professional use only -
Model: 238338 - Single Acting Bead Spray Gun
Model: 24G979 - Double Acting Bead Spray Gun
200 psi (1.38 MPa, 13.8 bar) Maximum Working Pressure
Important Safety Instructions
Read all warnings and instructions in this
manual. Save these instructions.
ti16176b
5949b
Single Acting Bead Spray Gun
Double Acting Bead Spray Gun
II 2 G
T5
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Warnings 2 308612J Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama-tion point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manua...
Installation 308612J 3 Installation Accessories are available from Graco. Be sure all accessories are properly sized to withstand the pres-sures in the system. Mount Valve Mount the valve on a 0.50 in. (12.7 mm) diameter rod on a mounting fixture or a dispensing machine. The bead gun has a clamping ...
Operation 4 308612J Operation Pressure Relief Procedure 1. Shut off air supply to the bead tank. Relieve pres- sure from bead tank. 2. Close the master air valve (required with air-pow- ered pumps). 3. Actuate the dispensing valve to relieve pressure. 4. Leave the drain valve(s) open until you are r...
