Giant LP122A - Manual
Giant LP122A – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INSTALLATION INSTRUCTIONS; IMPORTANT OPERATING CONDITIONS
- Page 3 – Specifications; PULLEY INFORMATION; S e l e c t G P M r e q u i r e d , t h e n s e l e c t; HORSEPOWER INFORMATION; REQUIREMENTS
- Page 6 – p u m p; LP255 PULLEY SELECTION AND HORSEPOWER REQUIREMENTS
- Page 7 – PUMP SYSTEM MALFUNCTION; Recommended Spare Parts
- Page 8 – . To disassemble the valve, screw the bolt into the retainer
- Page 9 – TO REASSEMBLE PROCEED AS FOLLOWS:
- Page 12 – GIANT INDUSTRIES LIMITED WARRANTY
Models
LP122A/LP122A-4000/LP123/LP255
Triplex Ceramic
Plunger Pump
Operating Instructions/
Repair and Service Manual
Contents:
Installation Instructions:
page 2
Pump Specifications - LP122A/LP122A-4000 page 3
Pump Specifications - LP123:
page 3
Exploded View:
page 4
Parts List/Kits:
page 5
Pump Specifications - LP255:
page 6
Trobleshooting Guide:
page 7
Suggested Maintenance Schedule:
page 7
Repair Instructions/Torque Specs.:
pages 8-10
Dimensions:
page 11
Warranty Information:
back page
Updated 12/06
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 NOTE: Contact Giant Industries for Service School Information. Phone: (419)-531-4600 INSTALLATION INSTRUCTIONS Installation of the Giant Industries, Inc., pump is not acomplicated procedure, but there are some basic stepscommon to all pumps. The following information is tobe considered as a genera...
3 Specifications Models LP122A/LP122A-4000/LP123 *Pump speeds of 640 RPM and above require a minimum inlet pressure of 12 psig. **Pump speeds of 805 RPM and above require a minimum inlet pressure of 14 psig. U.S. ..................................... (Metric) Volume (Continuous) .......................
6 Specifications Model LP255 U.S. ..................................... (Metric) Volume ................................................................. 26.0 GPM ............................ (98 l/min)Discharge Pressure ............................................. 2175 PSI ...........................
