Gefen EXT-HDMI1.3-442 - Manual

Page 2 - ASKING FOR ASSISTANCE; Technical Support

ASKING FOR ASSISTANCE Rev B3 Technical Support : Telephone (818) 772-9100 (800) 545-6900 Fax (818) 772-9120 Technical Support Hours: 8:00 AM to 5:00 PM Monday thru Friday PST Write To: Gefen, LLC.c/o Customer Service20600 Nordhoff St Chatsworth, CA 91311 [email protected] Notice Gefen, ...

Page 3 - CONTENTS

CONTENTS 1 Introduction 2 Operation Notes 3 Features 4 Panel Layout 5 Panel Descriptions 6 Connecting And Operating The 4x2 Switcher For HDMI 1.3 7 IR Remote Control Description 8 IR Remote Installation 9 IR Remote Confi guration 10 IR Channel Confi guration 11 EDID Management 11 Internal EDID 12 Ex...

Page 4 - INTRODUCTION; Gefen

1 INTRODUCTION Congratulations on your purchase of the 4x2 Switcher for HDMI 1.3. Your complete satisfaction is very important to us. Gefen Gefen delivers innovative, progressive computer and electronics add-on solutions that harness integration, extension, distribution and conversion technologies. ...

Page 5 - OPERATION NOTES

2 READ THESE NOTES BEFORE INSTALLING OR OPERATING THE 4X2 SWITCHER FOR HDMI 1.3 • By default, display information from the display connected to HDMI output port 1 is sent back to the source. Therefore, the other display connected to the 4x2 Switcher for HDMI 1.3 must be capable of accepting the timi...

Page 6 - FEATURES; • Lip; Features; Maintains sharp HDTV resolutions up to 1080p Full HD and 2K; Package Includes

3 FEATURES HDMI 1.3 Features • 225 MHz (up to 12 bit YUV 444 supported @ 1080p) • Deep Color • Dolby TrueHD and DTS-HD Master Audio • Lip Sync • CEC Pass-Through Features • Easily switch between any four (4) Hi-Def sources on up to two (2) HDTV displays without signal loss • Maintains sharp HDTV res...

Page 7 - PANEL LAYOUT; Front Panel

4 PANEL LAYOUT Front Panel Back Panel 1 2 3 4 5 6 7 8 9 10 11 12

Page 8 - PANEL DESCRIPTIONS; Connect up to two (2) HDTV displays to these HDMI output ports.

5 PANEL DESCRIPTIONS 1 Power Indicator This LED will become active once the included 5V DC power supply is properly connected between the unit and a open wall power receptacle. 2 IR (Infrared) Receiver This receiver will accept command for switching between input HDMI devices using the included RMT-...

Page 9 - How to Connect the 4x2 Switcher for HDMI 1.3; using the supplied HDMI cables.; Wiring Diagram for the Gefen 4x2 Switcher for HDMI 1.3; CONNECTING AND OPERATING

6 How to Connect the 4x2 Switcher for HDMI 1.3 1. Connect up to two HDMI source devices to the 4x2 Switcher for HDMI 1.3 using the supplied HDMI cables. 2. Connect up to four HDMI capable devices to the 4x2 Switcher for HDMI 1.3 using the supplied HDMI cables. 3. Connect the included 5V DC power ada...

Page 10 - IR REMOTE DESCRIPTION; LED Button Press Indicator; RMT-4IR Remote Control Unit

7 IR REMOTE DESCRIPTION 1 LED Button Press Indicator This LED will be activated momentarily each time a button is pressed. 2 Display and Source Selection Buttons These buttons are used to select which source is routed to the displays. Example: Route the source connected to Input 3 to the displays co...

Page 11 - Installing the IR Remote Control Battery; Remove the battery cover on the back of the IR Remote Control unit.; IR REMOTE INSTALLATION; Battery Compartment

8 Installing the IR Remote Control Battery 1. Remove the battery cover on the back of the IR Remote Control unit. 2. Insert the included battery into the open battery slot. The positive (+) side of the battery should be facing up. 3. Replace the battery cover. The Remote Control unit ships with two ...

Page 12 - IR REMOTE CONFIGURATION; Setting the IR Remote Channel on the RMT-8IR; The DIP Switch bank is located underneath the battery cover.

9 IR REMOTE CONFIGURATION Setting the IR Remote Channel on the RMT-8IR In the event that IR commands from other remote controls confl ict with the supplied IR Remote Control Unit, changing the remote IR channel will fi x this issue. The IR Remote Control Unit has a bank of DIP switches for setting t...

Page 13 - IR CHANNEL CONFIGURATION

10 IR CHANNEL CONFIGURATION Setting The IR Channel Use the following procedure to set the proper IR channel on the 4x2 Switcher for HDMI 1.3. 1 Press and hold the EDID button. 2 While holding the EDID button, press and release the Reset button. The input LED indicators, on the front panel, will repr...

Page 14 - EDID MANAGEMENT

11 EDID MANAGEMENT EDID Mode Selection 1. EXTERNAL MODE : See page 10 for details on using the External EDID. 2. INTERNAL MODE : To use this mode, press the EDID button on the rear panel until the front-panel LED marked “Int” turns bright green. This mode will use a preset EDID, from the factory, th...

Page 15 - External EDID Management; enabled

12 EDID MANAGEMENT External EDID Management The 4x2 Switcher for HDMI 1.3 features EDID Management. Before the source can send video or audio signals, the source device reads the EDID (Extended Display Identifi cation Data) from the output devices connected to the Splitter. The EDID contains informa...

Page 16 - SPECIFICATIONS

13 Video Amplifi er Bandwidth ............................................................... 225 MHz Input Video Signal ...................................................................... 1.2 Volts p-p Input DDC Signal ................................................................ 5 Volts p-p ...

Page 17 - WARRANTY; Proof of sale may be required in order to claim warranty.; PRODUCT REGISTRATION; under the Support section of the Gefen Web site.

14 WARRANTY Gefen warrants the equipment it manufactures to be free from defects in material and workmanship. If equipment fails because of such defects and Gefen is notifi ed within two (2) years from the date of shipment, Gefen will, at its option, repair or replace the equipment, provided that th...

Page 18 - Pb

20600 Nordhoff St., Chatsworth CA 91311 1-800-545-6900 818-772-9100 fax: 818-772-9120 www.gefen.com [email protected] Rev B3 Pb This product uses UL listed power supplies.

Gefen EXT-HDMI1.3-442 - Manual

Table of Contents:

Summary

Other Gefen Models