GE ZXR758 Manual - Free PDF Download

Page 2 - IMPORTANT; Note to Installer; CONTENTS

Installation Preparation WARNING: TO REDUCE THE RISK OF FIRE, ELECTRICALSHOCK OR INJURY TO PERSONS, OBSERVETHE FOLLOWING:A. Use this unit only in the manner intended by the manufacturer. If you have any questions, contact themanufacturer. B. Before servicing or cleaning unit, switch power off at the...

Page 3 - Installation Preparation; REQUIRED ACCESSORIES; recirculating; PRODUCT DIMENSIONS

Installation Preparation 3 REQUIRED ACCESSORIES This book provides step by step instructions to install theMonogram ZV750 wall mounted hood for recirculating operation.• One of the following accessory kits is required for non-vented wall mounted installations of model ZV750. Choose the correct kit a...

Page 4 - POWER SUPPLY; Electrical supply; DUCT COVER ACCESSORIES; ZV750SY Duct Cover Dimensions

Installation Preparation 4 POWER SUPPLY IMPORTANT – (Please read carefully) WARNING: FOR PERSONAL SAFETY, THIS APPLIANCE MUSTBE PROPERLY GROUNDED. Remove house fuse or open circuit breaker beforebeginning installation. Do not use an extension cord or adapter plug withthis appliance. Follow National ...

Page 5 - Check Installation Hardware; REMOVE THE PACKAGING; • Lift the hood out of the box, using hand grips on

Installation Preparation 5 Check Installation Hardware Locate the hardware accessory box packed with thehood and check contents. REMOVE THE PACKAGING The vent hood is shipped secured to a shippingboard with 4 screws.• Remove the duct cover, parts box and styrofoam packaging. • Lift the hood out of t...

Page 6 - Installation Instructions; DETERMINE INSTALLATION; House Wiring Locations

Installation Instructions 6 1 DETERMINE INSTALLATION LOCATION To determine the exact location of the vent hood. • Locate the template packed with the literature. – Measure 36" from the floor to the top of the cooking surface. Add 25-1/2" recommendedspace from the cooking surface to the botto...

Page 7 - INSTALL AIR DEFLECTOR; Do not overtighten screws.; SIZE DUCT PIECE

Duct Length Measure Length Installation Instructions 7 5 INSTALL AIR DEFLECTOR ASSEMBLY • Place the assembly over the hood outlet.• Hold the assembly against the ceiling. The penciled centerline should show through the slot on thedeflector. Mark the two screw holes on the back ofthe assembly. • Remo...

Page 8 - INSTALL DUCT COVERS AND

Installation Instructions 8 7 INSTALL DUCT COVERS AND UTILITY BARS • Separate the duct covers supplied with the hood.• Discard the upper (inner) section.• Insert the ZXR758 or ZXR7510 duct cover (with vent holes) into the original lower section. Be surethat the new duct section is inside the shorter...

Page 9 - FINALIZE INSTALLATION; • Remove the protective film covering the control; INSTALL FILTERS; • Install all 3 charcoal filters.; Install Charcoal Filters; • There are two slots inside the back and front of the

Installation Instructions 9 9 FINALIZE INSTALLATION • Remove the protective film covering the control panel on the front face of the hood, and any otherpackaging materials. • Refer to the Owner’s Manual for operating instructions. Upper Charcoal Filter Slots Grasp Tab, Lift and Pull Forward 8 INSTAL...