GE PT7800SH9SS - Installation Manual

GE PT7800SH9SS – Installation Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

Page 2 – CUTOUT FOR SINGLE OVENS – UNDER COUNTER; One cooktop may be centered over either; Install two ovens in separate cutouts.; Continue to Section 4.; Cabinet Width; Maintain; CUTOUT FOR SINGLE OVENS IN WALL CABINET; shim both sides equally to establish the cutout width.
Page 3 – CUTOUT FOR DOUBLE OVENS (2 THERMAL OVENS); Continue to Section 3.
Page 5 – The door for the microwave oven on a combination oven; DO NOT LIFT THE DOOR BY THE; ELECTRICAL REQUIREMENTS; WARNING; This appliance must be properly grounded.; WARNING
Page 6 – MAKE ELECTRICAL CONNECTIONS; THREE-CONDUCTOR BRANCH CIRCUIT CONNECTION; If residence leads are aluminum conductors, see; Connect the oven ground conductor along with the; KW Rating
Page 7 – Mounting; SLIDE OVEN INTO OPENING
Page 8 – Oven Installations without a Pedestal
Page 9 – ADVERTENCIA; Instrucciones de instalación; Hornos de pared eléctricos empotrados de 27” y 30”; INSTALACIONES DE HORNO ÚNICO
Page 10 – ABERTURA PARA HORNOS ÚNICOS – BAJO EL MOSTRADOR DE ENCIMERA; Continúe en la sección 4.; Una estufa puede centrarse sobre cualquier; Estufa; Dimensión; ABERTURA PARA HORNOS ÚNICOS EN UN GABIENTE DE PARED
Page 11 – ESPACIO PARA HORNOS COMBINADOS (CON HORNO; Continúe en la sección 2E.; Descripción; ABERTURA PARA HORNOS DOBLES (2 HORNOS TÉRMICOS); Continúe en la sección 3.
Page 13 – La puerta del horno microondas en un horno; ¡NO LEVANTE LA PUERTA DE LA; REQUISITOS ELÉCTRICOS; Posición destrabada de la bisagra
Page 14 – REALICE LAS CONEXIONES ELÉCTRICAS; CONEXIÓN DE CIRCUITO DERIVADO DE TRES CONDUCTORES; Rojo
Page 15 – CONEXIÓN DE CIRCUITO DERIVADO DE CUATRO
Page 16 – Ranura de la bisagra; INSTALACIÓN DEL REBORDE INFERIOR; Instalación de Hornos Simples, Combinados; Instalaciones de Horno de Pared

Loading the manual

BEFORE YOU BEGIN

Read these instructions completely and
carefully.

•

IMPORTANT

—

Save these

instructions for local inspector’s use.

•

IMPORTANT

—

Observe all

governing codes and ordinances.

•

Note to Installer –

Be sure to leave these

instructions with Consumer.

•

Note to Consumer –

Keep these

instructions for future reference.

•

Skill level –

Installation of this appliance

requires a qualified installer or electrician.

•

Proper installation is the responsibility
of the installer.

•

Product failure due to improper installation
is not covered under Warranty.

•

Product is for indoor use only.

Installation Instructions
27” & 30” Electric Built-In Wall Ovens

FOR YOUR SAFETY:

WARNING

Before beginning the installation, switch power off at the service panel and lock

the service disconnecting means to prevent power from being switched on accidentally. When the
service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a
tag, to the service panel.

Be sure the oven is securely installed in a cabinet that is firmly attached to the house structure. Weight
on the oven door could cause the oven to tip and result in injury. Never allow anyone to climb, sit,
stand or hang on the oven door.

Make sure the wall coverings, counters and cabinets around the oven can withstand the heat (up to
200°F [93.3°C]) generated by the oven.

MATERIALS YOU MAY NEED

Junction Box

Wire Nuts

Strain Relief Clamp for 1/2” Conduit

36” (91 cm) of String

TOOLS YOU MAY NEED

1/8” Drill Bit and Electric or Hand Drill

T20 Screwdriver

Phillips Screwdriver

Wire Strippers

7/16” Nut Driver (combination ovens)

1/4” Nut Driver (30” combination ovens)

ATTENTION INSTALLER:

All electric wall ovens must be hard-wired (direct-wired)

into an approved junction box. A plug and receptacle is NOT permitted on these products.

Questions? Call us at 1.800.432.2737 or visit GEAppliances.com.
In Canada, call 1.800.561.3344 or visit GEAppliances.ca.

REMOVE PACKAGING MATERIALS

Failure to remove packaging materials could result in damage to the appliance. Remove all
packing parts from oven, racks and heating elements. Remove protective film and labels on
the outer door and control panel. Also, remove plastic on trims and panel, all tape around the
oven and any shipping screws securing the oven to the base pad. Open oven door and remove
literature pack and oven racks. Remove the bottom trim from the top of the oven. It will be
installed at the end of the installation process. The trim is wrapped separately and taped to the top
of the unit. Remove pedestal rails from separate box and set aside (30” Double Wall Ovens Only).

Consider recycling options for your appliance packaging material.

PREPARE THE OPENING

NOTE:

If the cabinet does not have a solid

bottom, two braces or runners must be
installed to support the weight of the oven.
For single ovens, the runners and braces
must support 220 lbs (99 kg). For double and
combination ovens, the runners and braces
must support 400 lbs. (181 kg).

NOTE:

If marks, blemishes or the cutout

opening are visible above the installed oven,
it may be necessary to add wood shims
under the runners until the marks or opening
are covered.

NOTE:

If the cabinet does not have a front

frame and the sides are less than ¾” (1.9 cm)
thick, shim both sides equally to establish the
cutout width.

DESIGN INFORMATION

SINGLE OVEN INSTALLATIONS

The single oven may be installed in a cabinet alone or above a warming drawer. The single oven
may also be installed side by side, below a countertop, or below specified cooktops. See the label
on top of the oven for approved models.

DOUBLE AND COMBINATION OVEN INSTALLATIONS

A double or combination oven may be installed in a cabinet alone or above a warming drawer.
See the label on top of the oven for approved models.

IMPORTANT:

Always refer to individual installation instructions packed with each product for

specific requirements.

Suitable
Bracing
to Support
Runners

2" x 4" (5 cm x 10 cm)

or Equivalent Runners Level

with Bottom of Cutout

and Flush with Sides of Cutout

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Was this manual helpful?

About this manual

Brand: GE
Model: PT7800SH9SS
Document type: Installation Manual
Language(s): English
Pages: 16
File size: 1.2 MB
Format: PDF

Summary

Page 2 - CUTOUT FOR SINGLE OVENS – UNDER COUNTER; One cooktop may be centered over either; Install two ovens in separate cutouts.; Continue to Section 4.; Cabinet Width; Maintain; CUTOUT FOR SINGLE OVENS IN WALL CABINET; shim both sides equally to establish the cutout width.

2 B CUTOUT FOR SINGLE OVENS – UNDER COUNTER NOTE: These ovens are only approved to be installed under the specific models as labeled on the unit. NOTE: One cooktop may be centered over either oven in the side-by-side installation. Cutout – observe all dimensions and requirements. 2” (5.1 cm) Min. 30...

Page 3 - CUTOUT FOR DOUBLE OVENS (2 THERMAL OVENS); Continue to Section 3.

2 C CUTOUT FOR DOUBLE OVENS (2 THERMAL OVENS) NOTE: If the cabinet does not have a front frame and the sides are less than ¾” (1.9 cm) thick, shim both sides equally to establish the cutout width. 2 D CUTOUT FOR COMBINATION OVENS (WITH UPPER MICROWAVE OVEN) NOTE: If the cabinet does not have a front...

Page 5 - The door for the microwave oven on a combination oven; DO NOT LIFT THE DOOR BY THE; ELECTRICAL REQUIREMENTS; WARNING; This appliance must be properly grounded.; WARNING

4 A DOOR REMOVAL (RECOMMENDED FOR THERMAL OVENS) WARNING The door for the microwave oven on a combination oven should never be removed, unless by a certified technician. NOTE: Door removal is not a requirement for installation of the product but is an added convenience. To remove the door:A. Open th...