Gaggenau ED 220/221-6 - Manual

3.1 Important notes Before operating the appliance for the first time,please pay attention to the following notes: Read through these instructions attentively beforeoperating the appliance for the first time. Remove the packaging from the appliance anddispose of it properly.Pay attention to the fact...

3.4 Determining water hardness Water hardness range 4 has been pre-entered on the appliance. If the hardness of the water in yourhousehold should deviate from this value, thecorrect water hardness range (between 1 and 4) must be entered before commencing operation of the appliance . You can find out...

3.5 Entering the water hardness If the hardness of the water in your householddeviates from the value that is set at the works(water hardness range 4), you must enter the right water hardness in the options menu forcommencing operation of the appliance. Proceed as follows: – T urn the two control kn...

13 4.1 Switching on and off Switching on Switching off 4.2 Control knobs Switching on – T urn the “Temperature” control knob by one latching position to the right (Fig. 12).The lighting goes on: – T urn the “Moisture level” control knob to the moisture level you require. – T urn the “Temperature” kn...

4.4 Operating the timer The required moisture level and temperature canbe set before and after time programming byturning the “Temperature” or “moisture level” knob. As long as one or several symbol(s) in the displayflash(es), no input is possible and no value is pro-grammed or an invalid value has ...

16 Setting the time of dayProceed as follows: – Press the (Timer) key 3 times . The (Time unit) symbol flashes on the display. The time display shows the currently set time of day (Fig. 15). – You can select the required time by pressing the + or – key. – Press the (Confirmation) key to confirm the ...

Short time You can program a period of time with the shorttime function without automatic activation ordeactivation. You can use this mode of operationeven when the appliance is switched off as an eggtimer, for example. The range that can be set isbetween ten seconds (00:10) and 23.59 hours(23:59) P...

22 5.3 Core temperature sensor Using the core temperature sensor, during thecooking process you can measure the coretemperature of the food you are preparing exactlybetween 1 °C / 5 °F and 99 °C / 210 °F . The sensormeasures the temperature in the interior of themeat. It indicates when the set core ...

5.6 Display of the current cooking compartment temperature(ThermoTest) 5.7 Power failure protection 5.8 Holiday protection 5.9 Cleaning aid When you press the (Confirmation) key, the current temperature in the cooking compartmentand the moisture level appears on the display for a few seconds (Fig. 2...

Cooking table 30 Dish Cooking insert selection * Quantity (end weight) MEAT Fillet in puff pastry perforated with baking paper 1 - 1,5 kg Roast pork with rind wire grill, unperforated 1,5 kg Leg of lamb (Low-temperature cooking) perforated 1,5 - 2,5 kg Roast beef (Low-temperature cooking) perforated...

Baking table 32 Cakes and biscuits Temperature Moisture Cooking time Special notes (app. in min.) Apple tart 170 - 190 °C / 340 - 375 °F 30 % 30 - 45 Swiss roll 190 - 210 °C / 375 - 410 °F 0 - 30 % 7 - 9 Small flaky pastry cakes 180 - 200 °C / 355 - 390 °F 80 - 100 % 15 - 25 Bread (1 kg) ** 200 /165...

9.2 Cleaning the side plate – Allow the appliance to cool down completely before cleaning it. – Be careful that no small parts fall into the base strainer. – Pull out the left shelf after undoing the knurled nut on the front side. – The grease filter can be detached in the upward direction. – To rem...

10.1 General 10.2 Lamp replacement The appliance must always be disconnectedfrom the mains when being repaired. If the appliance does not function correctly, checkthe fuses and the water supply connection first.If the power and water supply is functioningcorrectly, but your appliance still does not ...

10.4 Disassembly of the front window Proceed as follows: – Remove the bottom screw from the door handle. – Remove the top screw from the door handle and detach the door handle. – Hold the front window with one hand and lightly shake the door to and fro. The glass window canbe removed towards you.You...

10.5 Remedying small malfunctions yourself If you cannot remedy a malfunction yourself with reference to the list below:– Switch off the steam oven and isolate the appliance from the mains.– Shut off the water supply.– Do not open the housing of the appliance.– Call Gaggenau after-sales service. 41 ...