Furuno SC-50/110 - Manual

Furuno SC-50/110

Furuno SC-50/110 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
Page: / 30

Table of Contents:

  • Page 3 – Contents
  • Page 7 – Fig.4 COMPASS display; ) R MONITOR display; “Rate sensor Monitor” display shows rate sensor errors as below.
  • Page 9 – Fig. 8 Rate error display
  • Page 10 – Figure 12 shows an example of Antenna Monitor display.; Elapsed time; Fig.12 ANT MONI display; ALARMS
  • Page 12 – Tracking error rate
  • Page 13 – SOFTWARE VERSION
  • Page 14 – To upgrade the program on the MAIN board
  • Page 15 – To upgrade the program on the CPU board
  • Page 16 – Line voltage check; Line voltages are checked at J3 on the MAIN board.
  • Page 17 – Location of Parts; PWR Board; Fig. 17 Processor Unit with cover removed; TP3 TP4 VR80 VR79 (not shown)
  • Page 19 – Appendix 1 Protection of ICs in Data Output Circuit; Refer to Appendix 2 for permanent remedy.; Symptom; screw fixing the MAIN board. See the attached sheet.; Factory-modified sets; Zener diodes added
  • Page 20 – Fabrication of Signal Cable; the armor. The installation manual will be revised.; Twist and cut
  • Page 21 – Fig. 3 Connection of grounding wire
  • Page 22 – Adding Zener Diodes; Type: RD9.1EB3-T4
  • Page 24 – Appendix 2 Modification on Data Output Circuit; changed from 4 pins to 5 pins for the connection of cable shield.; Before modification; Fig.1 Connection on DATA OUT port
  • Page 25 – 演算部
  • Page 26 – GPS
Loading the manual

SATELLITE COMPASS

SC-50/110

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 3 - Contents

Contents 1. Overview ...................................................................................... 1 2. Maintenance Menu ....................................................................... 2 1 ) MONITOR display ...............................................................................

Page 7 - Fig.4 COMPASS display; ) R MONITOR display; “Rate sensor Monitor” display shows rate sensor errors as below.

3 Shows difference between GPS and rate sensor. Shows an error. 1: error, 0: no error 1 normally Factory use Factory use 2) COMPASS display MASK-EL is used to set a minimum elevation angle of the satellite. The satellite of which elevation angle is lower than MASK-EL is not used for heading calculat...

Page 9 - Fig. 8 Rate error display

5 Number of consecutive errors (For example, an error message appears with three consecutive ROL errors.) 5) RATE ERR display This menu sets the level to trigger the heading error alarms; NO HEADING OUTPUT and RATE ERROR. The system compares the output of the angular rate sensor with one obtained by...

Other Furuno Models

All Furuno Other